User's Manual

20
The AirCross 2 is equipped with a Manfrotto quick release baseplate and
a plate which make it facile for users to change shooting equipment.
When using the Manfrotto quick release system, please install the
baseplate onto the longer end of the L-Bracket, so that the knob screw
onto the baseplate is exposed. Then fix the camera onto the release
plate.
By default, the camera handle side is located near the tilt motor to allow
an unobstructed access to the camera control ports; however under
some special circumstances, the camera control ports side should be
located near the tilt motor.
Rightward installation is required under the following situations:
a. The camera size is too wide like BMPCC.
b. A specialized camera cage is used.
c. The camera lens is too heavy to adjust the balance
Notes:
1. Some camera cages are equipped with ARCA standard release plate.
These special cages can be mounted directly on the AirCross 2. gimbal
without using the L-Bracket. 2.Some special cages have no Arca-Swiss
standard quick release plate on the side ,The Arca-Swiss quick release plate
can be mounted on the side of the camera rabbit cage with a 1/4" screw
and then mounted to AirCross 2. 3.When camera is mounted in this way, the
camera control port or HDMI port will be blocked.
Manfrotto Quick Release System
Two Camera Mounting Directions
Regular installation Rightward installation
Rightward Installation steps:
a. Mount the L-Bracket at the bottom of the camera with the short end
near the side of the lens;
b. Rotate the roll arm 180° until the tilt motor is located at the left side of
the roll motor;
c. Mount the shorter end of the L-Bracket on the release baseplate.