User's Manual

22
Specs
Note:
Make sure the gimbal is fully charged and the computer or mobile phone network
connection is normal during the upgrade.
Do not disconnect the gimbal from power, USB cable or Bluetooth during the
upgrade, otherwise the upgrade will fail.
Please re-install the batteries and try to upgrade again until the upgrade is
completed.
Specs
Body weight (g) Battery excluded 950
Payload (g)
Minimum 300
Maximum 3200
Dimension (mm) Storage dimension 335*225*90
Camera Tray Dimension
(mm)
Release center to roll axis 105
Release center to tilt axis 120
Release center to the peak of tilt
80
Mechanical Endpoint
Range (°）
Pan
360°continuous
Roll
360°continuous
Tilt 360°continuous
Operation Temperature
（℃）
Lowest 0
Highest 50
Operation Voltage Standard 7.2
Operation Current Dynamic (mA) 200
Battery
Model M2S30QB
Type
Li-ion
Standard capacity (mAh) 3000
Standard voltage (V) 7.2
Charging time (H) 1.5
Battery life (H) 12
Connections
Bluetooth 4.0 BLE
2.4G 50m
USB in USB -C
Camera control port Mini USB 10PIN
Accessory extension ports Multi-CAN*3
Upgrade via App:
a.Turn off the gimbal.
b.Long press the center button, then press the power button with the
other hand until the prompt ’BOOT MODE’ appears on the screen.
c.Start App, press Bluetooth to search for AirCross 2 device and
connect.
d.The App will automatically enter the firmware upgrade interface,
please wait for the firmware download to complete, press the
‘upgrade’ button and wait for about 5 minutes.
e.Restart the gimbal after the upgrade.