User Manual

Balance Parameter
There are four groups parameters for selecting
are listed as below:
1(Profile 1); 2(Profile 2);
3(Profile 3); 4(Profile 4);
Please begin with profile 4. If you get the vibration
with the current profile, select a lower one until the
vibration is gone. Or you can try the Auto-Tune
feature at the same interface.
Follow Mode
There are 4 kinds of follow mode, they are listed below:
Yaw-follow mode; Pitch-follow mode;
Pitch-yaw follow mode; All-lock mode;
Roll follow mode; User-defined;
Please check the page 10 to learn more about
operation mode.
Yaw/Pitch/Roll Adjustment Arm parameter setting.
The motor parameters for yaw/pitch/roll.
Follow Enable：Enable the follow mode at the current
Adjustment Arm.
Motion Control Enable：The current Adjustment Arm
is no longer functional at the Motion Control when it is
disable.
Manual Positioning Enable：The camera can lock on
at the specific position manually when the current
Adjustment Arm is no at the follow mode.
Follow Speed & Control Speed
Follow Speed
The speed of the Moza Air follow movement. Range
from 0-100.
Control Speed
The sensitivity of joystick speed to control the Moza
Air movement. Range from 0-100.
Auto Tune
Moza will tune the parameters automatically one time.
For some special camera setup the Auto-Tune couldn't
select the best profile for your Moza gimbal, please select
the profile manually.
Save Parameters
Save the parameters you set. Your Moza device will
automatically use the parameters pre-set well next time.
Reset Current Parameters
Reset current parameters and restore to its default
values.
Factory Reset
Rest all parameters and restore to its default values.
Moza Air User Manual
Parameter
21 22