User Manual

Mimic Motion Control
Mimic control calibration
MOZA Mimic Motion Control Tutorial Guide
Notice：Only apply to version D of the MOZA thumb controller
1. Pair Moza Air with the thumb controller (which has been paired after
manufacture).
2. Turn Moza Air on.
3. Calibration should be done when you use this function for the first time or drifts
and unstable situations occur, please refer to mimic control calibration.
4. Long press “OPTIONS” to enter the menu. Select “Motion Control”>> “Start”
to enter the mimic control mode.
5. The screen displays parameters of each axis after entering the mimic control
mode. If “Error” pops out on the screen, please check the thumb controller code or try
it again.
6. If the attitude of Moza Air is inconsistent with the thumb controller in mimic
control mode, long press “SPEED” button to pause mimic control, turn the thumb
controller to a desired position, then release “SPEED” to restart control when both
attitudes become consistent.
7. Move the joystick leftwards to exit the mimic control mode.
Select“ON”to enable the motion control on the current Adjustment Arm . Select
“OFF”to disable this function.
1. Place the thumb controller and Moza Air well like figure 1
2. Long press “OPTIONS” to enter the menu. Select “Motion Control”>>
“Motion Calib” to start calibration.
3. Keep the thumb controller still, until the screen displays “Success” or “Fail”.
If it shows “Fail” please make sure wireless thumb controller is keeping still or if it is a
D version controller.
Moza Air User Manual
Mimic Motion Control
33 34