Quick start Guide

B MOZA Mini-C
Phone Holder Lock
Tilt Motor
Phone Holder
Roll Motor
Phone Lock
Yaw Motor
1/4”Screw Hole
Adapter Ring
Micro USB Port
Joystick
Zoom Switch
ON/OFF&LED
Indicator LED
Handgrip
Battery Cover
Cord Hole
1/4”Screw Hole
Mini-C
Quick Start Guide
V2.0
Micro-USB X1 18650 Battery X1 Charger X1
Mini-C Gimbal X1 Start Guide X1
On-board Charging:
Insert the 18605 battery into the handgrip, connect the USB cable
to the gimbal. Then the indicator light will turn red. It takes 5 hours to
fully charge the battery. After the battery is sufficiently charged, the
indicator light will automatically turn off.
Charger:
You can also use the charger w/ the USB
cable in the box. Make sure the battery’s
positive terminal is facing the indicator side of
the charger. It takes about 5 hours to fully
charge the battery. When the charger light
indicates green the battery is fully charged.
1. Loosen the phone-locking knob by
turning the knob counter clockwise. Adjust
the width to fit your smartphone. Position
the bottom edge of the smartphone so that
it is flush against the tilt motor. Then turn
the phone-locking knob clockwise to secure
the smartphone in the holder.
2．With the power off. If your smartphone
is falling or not holding the horizon the
position of the smartphone holder will
need to be adjusted
3. If your smartphone is not holding the
horizon, the center of gravity will need to
be adjusted to achieve proper balance.
This is done be loosing the smartphone
holder (Large Ring) and by moving its
position further away from the tilt motor
or closer to the tilt motor.
For example to mount an iPhone 7 Plus, the smartphone holder
will need to be positioned as close as possible to the tilt motor.
Another example is an iPhone 6s, where the smartphone holder will
need to be positioned towards the middle.
4. To test if balance is correct. Lightly press
down on the tilt motor and release. If the
smartphone holds that position in space
without rising or falling your setup is
perfectly adjusted. Some users may still
have an issue finding the correct center of
gravity for their smartphone. In this case
adjust the smartphone to achieve the
slowest rate of rising or falling.
5. Loosen the battery cover and insert the
18650 battery into the handgrip positive
side up. Then secure the battery cover to
the bottom of the handle.
Notes: The stabilizer will not function if the battery is install
incorrectly or if the battery voltage is too low.
1. Loosen the smartphone holder
by turning the large ring
2. Rotate the phone holder
90 degrees.
3. Loosen the phone-locking knob to
widen the smartphone holder. Place
the smartphone in the holder in
portrait/vertical mode. Adjust the
position of the smartphone so that the
holder intersects with the middle of the
smartphone. Then tighten the phone-
locking knob to secure.
4. If the smartphone tends to fall to certain side, adjust the smart-
phone holder in the opposite direction of the fall.
Joystick
Control the gimbal movements: Up/down/left/right, Pan/Tilt.
Single press: Yaw-follow mode, tilt and roll are Locked.
Double press: Yaw-tilt follow mode, roll are Locked.
Long press: All-lock mode, tilt, yaw, and roll are locked.
ON/OFF
Single press: Take a photo or start/stop recording;
Double press: Switch between front-facing camera and rear camera;
Triple Press: re-center the gimbal to its starting position;
Long Press: Turn on/off;
Zoom Switch
Up: Zoom in
Down: Zoom out
Notes: To control your phone remotely over bluetooth, it is
required to install the MOZA Assistant App (currently only iOS
version available).
Yaw-Follow Mode:
Yaw-Tilt Follow Mode:
All-lock Mode:
Low Battery Level:
Firmware Upgrading:
Notes: Enter the firmware upgrading mode by pressing and
holding the joystick, then pressing the On/Off button. The motor-
s will not fucntion during firmware upgrading.
Vertical Mode:
Tilt the Mini-C to the right/left over by 45 degrees. The roll motor
will automatically rotate 90 degrees to vertical mode.
Notes: Vertical mode switch can be turned on/off in the MOZA
Assistant App.
Flashlight Mode:
Rotate the handgrip by 90 degrees so that the bottom of the
handgrip is pointed towards your abdomen.
A In the Box
C Charge the Battery
D Mount Your Smart Phone
F Handgrip Button Functions
G Light Status
E Live Streaming Mode
H Changing Operating Modes
LED
+
-