Use and Care Manual

Stain Woodgrain Guide

Application of a polyurethane top coat with UV inhibitors like ZAR™ Exterior polyurethane, Wood Kote®

Flagship UV, or Minwax® Fast Drying Polyurethane for exterior applications.

1. After stain has completely dried (48 hours), mix the top coat well and apply evenly using a clean dry 2” soft

bristle brush or 3” foam brush. Be sure to stop when the grain changes direction.

2. Apply two or three coats of ﬁnish, allowing at least 24 hours of drying time between each application.

Step 3: Protective Top Coat

Normal Maintenance

Even a well-ﬁnished door will be affected by exposure and weathering from sun, moisture, and air pollutants. It is considered

normal maintenance to re-apply the topcoat approximately every two years.

Due to the variability in finishing materials, application conditions and techniques, all of which are beyond the control of MP

Doors.

MP Doors cannot be responsible for the performance of field applied finishes or individual application techniques.

*Staining instructions are for Oil-Based, Premium Quality Wood Stains or similar product designed for use on composite

surface. Please note the instructions indicated are specific to the Zar brand stain. Please reference stain manufacturers

instructions before applying any stain.

CAUTION: Painting or staining MP Doors dark colors can result in poor performance and will void the warranty. Dark colors are

considered any color that falls within the lightness (L) value of 56 to 0, where 100 is white and 0 is black. Use paint or stain with a

light reflective value (LRV) of 57 units or greater.

1. If possible, lay door horizontally on a padded surface to

prevent scratches.

2. Remove all the hardware and mask off anything you don’t want

stained.

3. DO NOT SAND GRAINED COMPOSITE.

4. Wipe the door with mineral spirits to clean any dust or residue from

the surface. Allow door surface to dry completely before applying

stain.

Step 1: Surface Preparation

1. Pre-Mixed Stain (1/2 pint)

2. Mineral Spirits (4 ﬂ. oz.)

3. Top Coat/Sealer (20 ﬂ. oz.)

4. Two Clean Cloths

5. One Pair Protective Gloves

6. 3’’ China Bristle Brush

7. Two Stir Sticks

8. Finishing Instruction

Materials Needed

Apply stain with a 3” to 4” soft bristle brush, or rag to small sections of the door at a time. Apply enough stain

to ﬁll the door grain.

Step 2: Stain Application

With a clean, lint-free 24 x 24 inch cloth, softly wipe the surface until you reach your desired tone.

TIP: When the rag becomes saturated with stain, re-fold to work with a less-saturated section. Be sure to

use the same rag for the whole door.

After all the stain is brushed evenly you may add ﬁnishing touches by using a small 1” to 2” brush or cotton

swabs.

Additional coats may be applied to achieve desired look. Follow all stain manufacturers instructions for proper

application (if different) and compatibility information.