User Guide
7 | P a g e
Mount the valet switch in the vehicle (Requires a small screw hole. Usually put in the
driver’s kick panel (that’s the area forward of the door), the driver’s side of the center
console, or the underside of the dash.)
Connect one wire from the valet switch to the dark blue wire (pin A8) from the EVO-
ALL 20 pin connector > and connect the second wire from the valet switch to ground.
4. Parking Lights – Many newer vehicles turn on lights automatically when the vehicle is running, so
connecting the parking lights via the remote start has no benefit. If your vehicle does not have this
feature and you wish to have the remote start turn on your parking lights, make the following
connection:
Connect the brown/white negative (-) parking light wire (pin A14) from the EVO-ALL
20 pin connector to a relay (not included) and the relay will connect to the vehicles
positive (+) yellow/blue or purple white parking light wire located @ pin-6, in the 10-pin
gray plug of your BCM.
Need to know where all the components go? See Installer’s Tip #1 later in this tip sheet
Need to know how to make your wiring connections? See Installer’s Tip #2 later in this tip sheet
STEP 3: Program the EVO-ALL
Programming for the EVO-ALL in vehicles listed, will accomplish 2 things: CAN data for body controls
and transponder bypass programming. You will need 2 separately coded keys, copy or clone keys will
not work. You must have 2 keys that will allow an additional key to be programed to the vehicle, as
the EVO-ALL will be programed into the vehicle using the Ford additional key learning procedure. Do
not have more than 1 key close to the key cylinder at the same time at any point in this process. You
must respect the time limitations as described. Begin by having all plugs unplugged from the EVO-
ALL and preform the following programming steps: