Owner`s manual

The warning labels shown here have been placed on the Base and Vertical Frame. If the labels are missing or

illegible, please call customer service at 1-800-888-8899 for replacements. Apply the labels in the location

shown.

IMPORTANT ASSEMBLY INFORMATION

 Tools Required for Assembling the Bench: Two Adjustable Wrenches and Allen

Wrenches.

 NOTE: It is strongly recommended that this equipment is assembled by two or more

people to avoid possible injury.

 Ensure Carriage Bolts are inserted through the SQUARE holes on components that need to

be assembled. Attach washer only to end of the Carriage Bolt.

 Use Allen Bolts or Hex Bolts inserted through the ROUND hole on components that need to

be assembled.

 Always wait until all bolts are assembled onto the bench before tightening the bolts. Do not

tighten each bolt right after it is installed

Fasten Nuts and Bolts

Securely tighten all Nuts and Bolts after all

components have been assembled in current and

previous steps.

NOTE: Do not over tighten any component with

pivoting function.

Make sure all pivoting components are able to move

freely.

Do not tighten all Nuts and Bolts in this step.

Guide Rod Installation

The Guide Rods (#19) has holes on the rod to lock the weight stack when

not in use. The shorter end of the guide rod with the lock hole will need

to be pointed downwards towards the Guide Rod Base (#8