User manual

A completed screen looks like this:

PSF Configuration Information Page 1

PSF configuration: NETWRKPRT Library: AFP

User resource library . . . . . . . . . . . . . : *JOBLIBL

IPDS pass through . . . . . . . . . . . . . . . : *YES

Activate release timer. . . . . . . . . . . . . : *NORDYF

Release timer . . . . . . . . . . . . . . . . . : *SEC15

Restart timer . . . . . . . . . . . . . . . . . : *IMMED

SNA retry count . . . . . . . . . . . . . . . . : 2

Delay time between retries. . . . . . . . . . . : 0

Blank page . . . . . . . . . . . . . . . . . . .: *YES

Page size control . . . . . . . . . . . . . . . : *YES

Resident fonts . . . . . . . . . . . . . . . . : *YES

Resource retention. . . . . . . . . . . . . . . : *YES

Edge orient . . . . . . . . . . . . . . . . . . : *NO

Remote location:

Name or address . . . . . . . . . . . . . . . . : *NONE

TCP/IP port . . . . . . . . . . . . . . . . . . : *NONE

TCP/IP activation timer . . . . . . . . . . . . : 170

PSF defined options: *NONE

Text description. . . . . . . . . . . . . . . . : IDATA IPDS DIMM

Device resource library list: *DFT

Note: The lines in bold in the above screen are not used by PSF/400.

Instead, PSF/400 uses the information entered in the device description screen.

Then do the following:

Ping the IP address to verify communication with the printer:

PING ’192.194.134.90’

Vary the printer on:

VRYCFG HP_IPDS CFGTYPE(*DEV) STATUS(*ON)

Start the print writer:

STRPRTWTR HP_IPDS

4.6 AS/400 Settings for Version 4.2

To configure IPDS on AS/400 V4R2, you use the following commands:

- CRTDEVPRT

- CRTPSFCFG

4.6.1 Configuring PSF with CRTDEVPRT on V4R2

At the AS/400 command line, enter a command in the form:

CRTDEVPRT DEVD(HP_IPDS) DEVCLS(*LAN) TYPE(*IPDS)

MODEL(0) LANATTACH(*IP) AFP(*YES) PORT(9100)FONT(11)

FORMFEED(*AUTOCUT) RMTLOCNAME('192.194.134.90)

USRDFNOBJ(AFP/NETWRKPRT *PSFCFG) TEXT('IDATA IPDS

DIMM')