User`s guide
HP Printer Adapter User’s Guide  5- 5 
No devices using Bluetooth 
technology appear in my 
discovered list 
Verify operation of the bt1300 and sending device: 
 Verify printer adapter is powered on and is in a ready state 
(solid green LED and blinking blue LED). If not, cycle 
power to the printer adapter. 
 Verify that the sending device is powered on. 
 Cycle power to the sending device, and then try discovering 
the printer adapter again. 
 If you are within range of more than one device and no 
other devices are found, contact the sending device 
manufacturer. 
My bt1300-equipped printer 
does not appear in my list of 
discovered devices 
Verify the following conditions: 
 Due to the client-caching scheme used in some software, the 
sending device may not immediately update the printer 
name. The previous printer name (the last printer the 
bt1300 was attached to when the client did a search) will 
instead appear in your list of discovered devices. 
 Ensure your bt1300-equipped printer is within range (a 
maximum of 10 meters or 33 feet, unobstructed). 
 Ensure the bt1300 security configuration is set to 
“discoverable”. 
 Cycle the bt1300 power, and then try discovering the printer 
adapter again. 
 Perform a cold reset on the bt1300 to return the printer 
adapter to factory default settings (the device will be set to 
“discoverable”). If the bt1300 still cannot be seen in your 
list of discovered devices and other devices are listed, call 
HP technical support. 
Cannot print to the printer 
adapter from my software 
After verifying there are no hardware or discovery problems as 
described above, verify the following conditions: 
 Verify a print connection by sending a V card to the printer 
(PIM over OBEX) or by sending a simple text document. 
 Verify bt1300-equipped printer is within a maximum 
unobstructed range of 10 meters or 33 feet. Note that the 
Bluetooth neighborhood will continue to show discovered 
devices even after the devices have been powered OFF. 
 Verify sending device driver installation. 
 Restart your print application (a print application such as hp 
mobile printing is required to print from a PDA). 
 Reboot your computer or PDA. 










