User`s guide

During installation, select a desired array and its associated LUN.
Select Manual Reboot at the end of the SunInstall utility screens and then verify your selections
to start the Sun Solaris OS installation.
Before rebooting after the installation completes, issue the luxadm display command on the
boot LUN.
See
Figure 8–3.
# luxadm display /dev/rdsk/c0t600015D0002028000000000000001142d0s2
DEVICE PROPERTIES for disk: /dev/rdsk/c0t600015D0002028000000000000001142d0s2
Vendor: SUN
Product ID: SE6920
Revision: 0202
Serial Num: 00500057
Unformatted capacity: 10240.000 MBytes
Read Cache: Enabled
Minimum prefetch: 0x0
Maximum prefetch: 0xffff
Device Type: Disk device
Path(s):
/dev/rdsk/c0t600015D0002028000000000000001142d0s2
/devices/scsi_vhci/disk@g600015d0002028000000000000001142:c,raw
Controller /dev/cfg/c4
Device Address 213600015d207200,0
FIGURE 8–2 Selecting an FC-based Boot Disk During Disk Selection
4
5
6
Installation Procedure
Chapter 8 • Sun Solaris 10 Update 6 x86/x64 Fibre Channel Operating System Booting Procedure 69