User`s guide

During the reboot process, watch the monitor so you can enter the HBA #1 BIOS screen and

specify the boot device to be the FC LUN onto which you just installed the Sun Solaris OS.

Follow this step for each HBA to be used for multipathing, and specify the boot device to be the

FC LUN on which you installed the Sun Solaris OS. See

Figure 8–4 and Figure 8–5.

■

For the QLogic HBA BIOS, perform the following steps.

a. During host rebooting, press Control-Q to display the HBA BIOS screen.

b. Select the HBA that you want to enable as the boot device and enable boot.

c. Congure the boot device:

i. Select Conguration Settings.

ii. Select Selectable Boot Settings.

iii. Make sure that Selectable Boot is set to enable.

In this menu, you can select the boot device/LUN by the array WWPN.

iv. Save and then exit the HBA BIOS screen.

■

For the Emulex HBA BIOS, perform the following steps.

a. During host rebooting, press Alt-E to display the HBA BIOS screen.

b. Select the HBA that you want to enable as the boot device and enable boot.

c. Select Congure Boot Devices.

d. Select a boot entry.

e. Select the WWPN of the desired boot device.

f. Type the LUN number.

g. Select the boot LUN.

h. Select Boot Device with the ArrayWWPN.

i. Save and exit the HBA BIOS screen.

Installation Procedure

Chapter 8 • Sun Solaris 10 Update 6 x86/x64 Fibre Channel Operating System Booting Procedure 71