Operation Manual

2
PREPARATION FOR USE
Unpacking and Setup
* Carefully remove the unit from the display carton and remove all packing material from the unit itself.
* Remove any descriptive labels that may be found on either the front or top cabinet of the unit. Do not
remove any labels located on either the back or button cabinet of the unit.
* Press the CD door OPEN Button to open the CD compartment door. There is a white card in the CD
compartment which is intended to prevent the CD pickup from moving during shipment of the product,
Remove this card from the CD compartment before use.
POWER SURRLY
Using AC Power
1. Check if the power voltage, as shown on the type plate located on the bottom of
the set, corresponds to your local AC power supply. If it does not, consult your
dealer or service centre.
2. Connect the power cord to the AC socket inlet and the wall outlet, the power
supply is now connected and ready for use.
3. To switch off completely, unplug the power cord from the wall outlet.
4. Unplug the power cord from the wall outlet to protect your set during heavy
thunderstorms.
Batteries (not included)
Open the battery compartment and insert six batteries, type LR14, UM-2 or C-cells,
(Preferably Alkaline) with the correct polarity as indicated by the + and -
symbols inside the compartment
Batteries contain chemical substances, so they should be disposed of properly.
Incorrect use of batteries can cause electronic leakage and will corrode the
compartment or cause the batteries to burst. Therefore:
Do not mix battery types: e.g. alkaline with carbon Zinc. Only use batteries of
the same type for the set.
When inserting new batteries, do not try to mix old batteries with new ones.