Operation Manual

6
USE CLOCK
To setup the time of the unit
1.Connect the AC on(The following operation must be in standby mode).
2.Short according to the time button, the time will flashing on the LCD display.
3.Press BACK、NEXT to select the number of the time. you can setup the time format
by 12h or 24h.
4.Press time button to confirm.
5.Then you can set the hour and the minute with the same method of steps 3-4.
6.(setup the alarm time, long press the time button can setup the unit begin alarm time
mode. With the same method of setps 3-4)
Note: After setup the unit time, the LCD will display the Radio/CD/USB/AUX
mode,
Press the Back or Next to choose the mode, then it press time button to affirm,
otherwise it play USB or AUX mode first.
RADIO
Radio reception
1.Press FUNCTION button select RADIO mode.
2.Tune to required station by press BACK/PRE-DN or NEXT/PRE-UP.
Manual Tuning: Press BACK or NEXT and then release within 1 sec.
Auto Tuning: Press the play/pause button enters the automatic scan channel
and to be enter the station automatically .
Preset Channel:(FM 30 Preset memories)
(1) Press BACK/PRE-DN or NEXT/PRE-UP to tuning by manual ,select
desired station.
(2) Press PROGRAM button , the Pre-set program begins steady in the display.
(3) Push PRE- DN or PRE-UP buttons to select the primary pre-set station
number.
(4) Press PROGRAM button to save your selected station.
(5) Repeat steps (1) to (2) procedures for other stations.
3.After end of program. Push PRE-UP or PRE-DN to start play the frequency that you
selected .
4.Push [VOL-]or [VOL +] to adjust the volume.
5.Extend TELESCOPIC ANTENNA to its full length if you are listening to FM
broadcasting.
6.Turn off the radio by press FUNCTION button select other mode or press power
button to off the unit.
7.Switch on again after shut down, the memory frequency still exists.