User's Guide

POLI User’s Guide

5. Config Mode

The menu in Config Mode is to adjust the POLI’s settings and calibrate sensors. It has the

following submenus:

• Sensor: Zero Calib, Span Calib, Bump Test, Span Value, Enable/Disable, Cal Interval,

Bump Interval, Gas Unit.

• Alarm: High Limit, Low Limit, STEL Limit, TWA Limit, Alarm Device.

• Datalog: Interval, Clear All, Log Sensor Sel.

• Unit Setting: Heart Beat Light, Temperature Unit, LCD Contrast, Pump Speed,

Language, Back Light Mode, LCD Auto Rotate, M-Down On/Off, M-Down Timeout,

M-Down Thresh.

• Wireless: Wireless On/Off.

• Exit

5.1 Entering Config Mode

To enter Config Mode, the [+/OK] and [ /↓] together for 3 seconds until you see the

password screen.

The Config Mode is password protected. The default password is ‘0000’. After all four

(4) digits are inputted, press [ /↓] key to enter config mode.

• Increase the number from 0 through 9 by pressing [+/OK].

• Step from digit to digit using [ /↓].

• After inputting the password’s four (4) digits, advance to ‘OK’.

• Press [+/OK] to register the password and enter Config Mode.

If the password input is not correct, you will receive the message ‘Incorrect!’ and the unit

will return to the reading mode automatically.

If the digit input is mistaken, use the [ /↓] key to move cursor among four digits and

press [+/OK] key to change the inputs.

After entering the config mode, the sensor menu is displayed first. Press [ /↓] key to

browse the menu under the config interface.