User's Guide

MUNI User’s Guide

5.5 Sensor Enable/Disable

Sensors can be disabled if they are not needed for a particular application, or if a sensor fails but

the other sensors still provide useful readings.

• To disable or enable a sensor, enter the Configuration Mode SENSOR ONOFF menu:

Config mode →→ SENSOR ONOFF?

• Press Left [+/OK] to enter and the On/Off status of the first sensor is flashing.

• Press Right [ /↓] to scroll to the desired sensor and press Left [+/OK] to toggle On/Off.

• Press Right [ /↓] until the display shows SAVE? And press Left [+/OK] to save.

5.6 Sensor Alarm Settings

All alarm limits can be customized, including High, Low, STEL and TWA alarms.

• Enter the Configuration Mode SENSOR ALARM? menu and scroll to the desired alarm:

Config mode →→→ SENSOR ALARM? → HIGH ALARM? → LOW ALARM? → etc.

• Press Left [+/OK] to enter the specific alarm sub-menu.

• Scroll Right [ /↓] until the desired sensor is flashing, and press Left [+/OK] to select the

sensor alarm, e.g., HI ALM 20.0?

• Press Right to highlight the desired digit and Left to change the alarm value. Hold down the

Left [+/OK] key for continuous number scrolling.

• Move the cursor to the ? and press Left [+/OK] to save.

• Repeat for other alarm limits as needed.

5.7 Monitor Set-up

This menu is used to adjust the date and time as for any numerical inputs. The date is in Year-

Month-Day format and the clock is in 24-hour format. The clock can also be set by

synchronizing with the PC, if that option is enabled using mPower Suite.

• Enter the Configuration Mode MNT SETUP? menu and scroll to DATE? Or TIME?:

Config mode →→→ MNT SETUP? → DATE? → TIME?

• Press Left [+/OK] to enter the specific sub-menu.

• Scroll Right [ /↓] until the desired digit is flashing, and press Left [+/OK] to change the

value. Hold down the Left [+/OK] key for continuous number scrolling.

• Press Right [ /↓] repeatedly until SAVE? Is displayed and press Left [+/OK] to save.