Instructions

Page 702 - Safety & Conformity
PRECAUTIONARY MEASURES
All safety instructions listed below must
be followed by each user:
• Any way of working that compro-
mises the safety of Mr Beam should
be avoided.
• The user is obliged to exclude the
commissioning of Mr Beam by unau-
thorized persons (e.g. by operating
devices against unauthorized use
and/or by removing the key)
• The socket must be easily acces-
sible and in the immediate vicinity
of the device. In an emergency,
the main plug and the key must be
disconnected immediately.
• The user must ensure that Mr Beam
is only operated under perfect condi-
tions.
• Before commencing each use, the
user is obliged to check Mr Beam
for externally recognizable defects,
damages or irregularities. Detected
changes, even unusual operating
behavior, must be remedied without
delay. The use of Mr Beam should
be discontinued until the defect has
been completely remedied.
• Cleanliness and clarity at and around
the workplace of Mr Beam must be
ensured.
• During the laser process, the
processed material is vaporized by
Mr Beam. The operation therefore
causes fire odors and vapors. Please
make sure that Mr Beam is operated
exclusively with the appropriate
suction/filter system.
• Shutting down and/or dismantling
of safety devices is prohibited at all
times. This can for instance lead to
severe burns and/or loss of sight.
• The work listed below must only be
carried out by trained personnel
when the device is switched off and
with the mains plug disconnected:
Set-up, retrofitting, maintenance
and inspection activities.
• If the disassembly of safety devices
is necessary for repair/maintenance
work, it is the responsibility of the
person carrying out the work to
reassemble them immediately and
before the next commissioning, and
to check for proper functioning.
• For safety reasons, any remode-
ling, modification or alteration of
Mr Beam is prohibited under any
circumstances.