Instructions

Page 56 Page 5707 - Maintenence & Care 07 - Maintenence & Care
REGULAR MAINTAINANCE & CARE
Regular maintenance and care is neces-
sary in order to maintain the high quality
results of your Mr Beam II. In addition,
depending on the application and mate-
rials used, regular general cleaning
is necessary. Always turn off the unit
and disconnect the power plug before
commencing cleaning and maintenance
work.
Warning: There is a fire hazard due to
insufficient cleaning and remaining pieces
inside Mr Beam II.
Regular maintenance & care
Please check before each use if dust
has accumulated in the interior of your
Mr Beam II. If dust has accumulated, your
Mr Beam II must be cleaned. Regular/daily
cleaning is recommended, the degree of
soiling strongly depends on the material
used. Only a regularly cleaned machine
can guarantee the best work performance
with optimum results.
To prevent dust from entering the inside of
the Mr Beam II when not in use, keep the
lid closed as often as possible.
Do not use aggressive or chlorine-cont-
aining cleaning agents for cleaning. We
recommend a mild soapy solution or the
use of commercially available detergent in
low concentrations.
Improper handling of chemicals can cause
damage to property and personal injury
for which the user alone is liable.
No tools are required for regular cleaning
and no parts need to be unscrewed.
Cleaning includes:
• Remove all materials, dirt particles
and deposits from the interior of
your Mr Beam II
• Vacuum the working area to remove
residues from the grid floor
• Dust all visible parts and surfaces of
your Mr Beam II
• Clean the safety cover only with a
cotton cloth/microfiber cloth. Do
not use paper towels as they may
scratch the acrylic
Caring of the guide bar
The mechanical guide bar must be regu-
larly cleaned of dust and dirt with a dry
cloth.
The guide bar must be oiled approximately
every 100 operating hours. Please note
that a small amount of machine oil (one to
two drops per rod) is sufficient. Only use
acid-free oils.
GENERAL CLEANSING
General cleansing
General cleaning is necessary at irregular
intervals depending on the use of your
Mr Beam II and the degree of soiling.
Please ensure cleanliness and clarity
at and around the workplace of your
Mr Beam II.
General cleaning includes all the above
mentioned steps of regular maintenance
and care. In addition, the base plate of
Mr Beam II is unscrewed to remove
persistent dirt between the grid floor and
base plate. To do this, follow the steps on
the following page.