Instructions

Page 2 Page 301 - Welcome 01 - Welcome
Warning: These operating instructions
must be carefully read and observed
before using Mr Beam II for the first time.
Non-observance of individually listed
points in the instructions manual can
cause personal injury and/or property
damage!
No part of this manual may be repro-
duced, edited or otherwise modified in
any form without the prior written consent
of Mr Beam Lasers GmbH. The rights for
reproduction in any form, in particular
in electronic, print and other media, are
reserved. Mr Beam Lasers GmbH reserves
the right to change specifications of the
hardware and software described in these
user manual at any time and without prior
notice.
The following symbols are used to facilitate
the understanding of this user manual:
Warning: This area represents a special
danger for the user or the person respon-
sible for maintenance if the operating
instructions are not observed.
Warning: In these areas, pay particular
attention to the possible dangers of laser
light.
Additional accessories must be compa-
tible with the base unit (if you have any
questions, please contact Mr Beam
Support: [e-mail]).
Please make sure you have the latest
version of the Mr Beam II user manual.
The latest version of the user manual can
be found at: www.mr-beam.org.
Please keep this user manual for future
reference.
This user manual is a translation from the
original user manual in german. Mr Beam
Lasers GmbH assumes no warranty for
translation errors.
Date of this manual: 18 September 2018
USING THIS USER MANUAL
Your Mr Beam II is designed for contact-
less cutting and engraving of various
materials. With the help of laser light,
heat is generated selectively to evaporate,
melt or burn materials. This thermal
process can be used to make cuts and
engravings on flat materials. Due to its
high precision, the process is suitable for
cutting out complex shapes and engraving
delicate designs.
The user can connect to Mr Beam II
with a computer or tablet via router or
directly via WiFi. Except for the browser
Google Chrome, no additional soft-
ware is required to operate Mr Beam II.
Mr Beam II is already equipped with all
necessary software and is operated by
the user via the web interface Mr Beam
Laserbench.
After files in common file formats have
been loaded into the Design Library, the
user can select predefined settings for the
material. The laser process is prepared
by the computer or tablet and started by
additionally pressing the button. A camera
allows a preview of the work surface,
which makes an exact
¹
placement of the
design on the workpiece possible.
Manufacturer
Mr Beam Lasers GmbH
Gollierstr. 70d
80339 Munich
Germany
MR BEAM II
¹ +/- 5mm (0.016 inch)