Full Product Manual
1. Remove the face of the
light by rotating counter-
clockwise as shown above.
Spotlight Features:
Motion/Light Sensor: Light instantly turns on when it detects
motion from up to 30 feet away. The light sensor conserves battey
life by preventing the light from activating in daylight.
Auto Shut-o: Light shuts o automatically after 20 seconds if no
motion is detected.
Bright LED: 200 Lumens covers up to 600 sq ft.
Durable, Weather Resistant: Tight seals and UV resistant material
allow the light to work in all weather conditions.
2. Pull face out from
cup to reveal battery
compartment.
Tips:
•
Use only new alkaline D-Cell batteries with 1.5V rating.
•
Do not mix old and new batteries. If batteries are not new, it may cause the light to malfunction.
•
Install batteries with polarity in correct position.
•
Light may activate when batteries are inserted. Simply take light into a dark room. Allow
batteries to settle, then test activation.
•
If your light will not turn o, it means that it is time to replace the batteries.
3. Push in battery door
tab and lift up to release.
5. Attach battery door by
matching the tabs to the
rectangular holes and then
push down on front until
the tab clicks into place.
6. Match arrows then turn
clockwise. Make sure
unit is securely closed
to activate weatherproof
seal.
7. Test the motion sensor
in a dark room for up to 5
minutes. When you re-enter
the room, the light should
activate with motion.
8. Remove mounting
base by turning
thumbscrew counter
clockwise. Pull
mounting base o stem
of light.
9. Determine
mounting location
and mark the pilot
holes. Use a drill to
insert anchors before
screwing in the base.
10. Drive the screws
through the holes on
mounting base. Insert the
stem back into mounting
base and tighten the
thumbscrew.
11. Loosen the knuckle
screw located on the stem
of the light, to point the
light in desired direction.
Then tighten the screw to
secure position.
When changing the
batteries, remove
the stem of the light
by twisting o the
thumbscrew. Note:
never change batteries
on ladder; doing so can
result in injury.
Changing Batteries
4. Insert 3 D-cell
batteries with correct
polarity. Make sure the
at ends of the batteries
are against the springs.
32333 Aurora Rd. Suite 100 Solon, OH 44139
877.298.9082
Installation Instructions
Wireless Motion Sensor LED Spotlight
MB360XT
• 1 Small Screwdriver
• 3 D-Cell Alkaline Batteries
• 1 Wireless Spotlight
• Mounting Base
• 3 Screws
• 3 Anchors
NOTE: Light sensor only allows Spotlight to activate in darkness. We recommend you test in a dark room or closet.
What you need to install:
Thank you for purchasing the Mr Beams
®
Wireless Spotlight. We are committed to
eliminating darkness using the latest in
Light-Emitting Diodes (LEDs). LEDs are the most
ecient and durable light sources available. We
are certain that your light will contribute to a safer
environment and provide light where you need it at
a very reasonable cost.
What is included per light:
www.mrbeams.com
LED Light
Mounting Base
Mounting Base
Thumb Screw
Knuckle Screw
Motion &
Light Sensor
* 1 year limited warranty. Visit site for details.
* Visit our website to view installation video.
Battery Caution:
1) Do not mix old and new batteries
2) Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmi-
um) or (Nickel Metal Hydride) batteries
3) Do not dispose of batteries in re
4)Batteries should be recycled or disposed of as per state and local guidelines