Instructions / Assembly
1. Remove front cover of Spotlight by rotating
counter-clockwise as shown above. Pull face out
from cup to reveal battery holder.
Spotlight Features:
Motion/Light Sensor: Light instantly turns on when it detects
motion from up to 30 feet away. The light sensor conserves battey
life by preventing the light from activating in daylight.
Auto Shut-off: Light shuts o automatically after 30 seconds if no
motion is detected.
Fully Adjustable: Light can be rotated 360° as well as up and down.
Bright LED: 140 Lumens covers up to 400 sq ft.
Durable, Weather Resistant: Tight seals and UV resistant material
allow the light to work in all weather conditions.
2. Push down on battery door tab to release. Insert 3
D-Cell batteries into Spotlight. Attach battery door by
matching the tabs to the rectangular holes and then
push down on front until door clicks into place. Light
will turn on and stay on as long as there is motion.
Tips:
•
Use only new alkaline D-Cell batteries with 1.5V rating.
•
Do not mix old and new batteries. If batteries are not new, it may cause the light to malfunction.
•
Install batteries with polarity in correct position.
•
Light may activate when batteries are inserted. Simply take light into a dark room. Allow
batteries to settle, then test activation.
•
If your light will not turn o, it means that it is time to replace the batteries.
4. Determine location for mounting Spotlight.
NOTE: For best performance, Spotlight should
be positioned so motion sensor is on top and
light is on bottom.
5. Remove mounting base by turning thumb
screw counter clockwise.
6. Pull mounting base o stem.
7. Drive three screws into the three holes located on
mounting base.
8. Insert spotlight stem back into mounting base
pointed in desired direction and tighten thumb screw
in base.
9. Loosen Knuckle screw that connects
Spotlight head to mounting base and adjust
Spotlight head to proper direction as shown
above. Tighten thumb screw.
3. Match arrows then turn clockwise. Make sure
unit is securely closed with arrow pointing
past the symbol to ensure weather proof seal
is tight.
32333 Aurora Rd. Suite 100 Solon, OH 44139
877.298.9082
Installation Instructions
Wireless Motion Sensor LED Spotlight
MB330/360
• 1 Small Screwdriver
• 3 D-Cell Alkaline Batteries
• 1 Wireless Spotlight
• Mounting Base
• 3 Screws
• 3 Anchors
NOTE: Light sensor only allows Spotlight to activate in darkness. We recommend you test in a dark room or closet.
What you need to install:
Thank you for purchasing the Mr. Beams
TM
Wireless Spotlight. We are committed to
eliminating darkness using the latest in
Light-Emitting Diodes (LEDs). LEDs are the most
ecient and durable light sources available. We
are certain that your light will contribute to a safer
environment and provide light where you need it at
a very reasonable cost.
What is included per light:
www.mrbeams.com
LED Light
Mounting Base
Mounting Base
Thumb Screw
Knuckle Screw
Motion &
Light Sensor
* 1 year limited warranty. See enclosed card for details.
* Visit our website to view installation video.
Battery Caution:
1) Do not mix old and new batteries
2) Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmi-
um) or (Nickel Metal Hydride) batteries
3) Do not dispose of batteries in re
4)Batteries should be recycled or disposed of as per state and local guidelines