Installation Guide

Step/Stair Light Features:
Motion/Light Sensor: Light instantly turns on when it
detects motion from up to 15 feet away. The light sensor
conserves battery life by preventing light from activating in
daylight.
Auto Shut-o: Light shuts o automatically after 20 or 60
seconds (optional) if no motion is detected.
Glow Mode Option: Emits soft glow when darkness is
sensed for safety.
Bright LED: 35 Lumens covers up to 120 sq ft.
Durable, Weather Resistant: Tight seals and UV resistant
material allow the Mr. Beams Light to work in all weather
conditions.
600 Beta Drive, Unit 100, Mayeld Village, OH 44143
877.298.9082
Installation Instructions
Step/Deck Light
MB520 / MB530
• 1 Small Screwdriver
• 3 C-Cell Alkaline Batteries
• Motion Sensor Step/Stair Light
• 2 Screws
• 2 Anchors
LED Light
Motion & Light
Sensor
NOTE: Light sensor only allows light to activate in darkness. We recommend you test in a dark room or closet.
What you need to install:
Thank you for purchasing the Mr Beams
®
Step/Stair Light. We are committed to eliminating
darkness using the latest in Light-Emitting Diodes
(LEDs). LEDs are the most ecient and durable
light sources available. We are certain that your
light will contribute to a safer environment and
provide light where you need it at a very
reasonable cost.
What is included per light:
www.mrbeams.com
1. Remove rear cover of light by
removing 2 screws on back.
2. Set auto shut-o to 20 or
60 seconds. Setting to min
will extend battery life.
4. Insert 3 C-Cell batteries.
5. Determine location for mounting the light. Flip rear cover upside
down and use holes for thumb screws as template to mark two
holes for anchors and/or screws (included). We recommend
mounting the screws parallel to the ground if mounting on a vertical
surface. Make sure that screws are precise distance from each
other as dened by the distance of the thumb screw holes. Replace
rear cover and tighten screws.
6. If using anchors, use 3/16” drill bit to drill holes and insert anchors. Drive screws
into anchors so that screw head potrudes 1/8” from the surface. If using only screws,
us 1/8” drill bit to drill holes and insert screws so that screw head protrudes 1/8” from
the surface.
7. Slide light down so screws are securely held by track.
3. Set “GLOW” to on if you want it to
glow in darkness or o for no glow.
Setting to o will extend battery life.
Tips:
•
Use only new alkaline C-Cell batteries with 1.5V rating.
•
Do not mix old and new batteries. If batteries are not new, it may cause the light to malfunction.
•
Install batteries with polarity in correct position.
•
Light may activate when batteries are inserted. Simply take light into a dark room. Allow
batteries to settle, then test activation.
•
If your light will not turn o, it means that it is time to replace the batteries.
* 1 year limited warranty. Visit site for details.
* Visit our website to view installation video.
Battery Caution:
1) Do not mix old and new batteries
2) Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium)
or (Nickel Metal Hydride) batteries
3) Do not dispose of batteries in re
4)Batteries should be recycled or disposed of as per state and local guidelines