Full Product Manual
Slim Safety Light Features:
Motion/Light Sensor: The light instantly turns on when it
detects motion from up to 15 feet away. The light sensor
conserves battery life by preventing activation in daylight.
Auto Shut-o: Light shuts o automatically after 20
seconds if no motion is detected.
Bright LED: 100 lumens covers up to 50 sq ft.
Durable, Weather Resistant: Tight seals and UV resistant
material allow the light to work in all weather conditions.
600 Beta Drive, Unit 100, Mayeld Village, OH 44143
877.298.9082
Installation Instructions
Wireless Motion Sensor LED Slim Safety Light
MB970
• 4 C-cell Alkaline Batteries
• Screwdriver or Drill
• Wireless LED Slim Safety Light
• 2 Screws & 2 Anchors
• Mounting Bracket
LED Light
Motion & Light
Sensor
NOTE: Light sensor only allows light to activate in darkness. We recommend you test in a dark room or closet before installation.
What you need to install:
What is included per light:
www.mrbeams.com
Tips:
•
Use only new alkaline C-Cell batteries with 1.5V rating.
•
Do not mix old and new batteries. If batteries are not new, it may cause the light to malfunction.
•
Install batteries with polarity in correct position.
•
Light may activate when batteries are inserted. Simply take light into a dark room, allow
batteries to settle, then test activation.
•
If your light will not turn o, it means that it is time to replace the batteries.
* 1 year limited warranty. Visit site for details.
* Visit our website to view installation video.
Battery Caution:
1) Do not mix old and new batteries
2) Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium)
or (Nickel Metal Hydride) batteries
3) Do not dispose of batteries in re
4) Batteries should be recycled or disposed of as per state and local guidelines
1. Remove the battery compartment by twisting the left side of the
light counterclockwise and the right side counterclockwise.
2. In the left compartment insert 2 C-cell
batteries with the negative side down.
3. In the right compartment insert 2 C-cell
batteries with the negative side down.
5. To remove the mounting plate from the light, use your nger to push up on the
mounting bracket tab. This will unlock the bracket. Then slide the light o the bracket.
7. Line up the light with the mounting plate and slide the light into
the grooves. Then rotate the light to desired angle.
4. Twist the compartments back into place.
6. Determine mounting location for the light. Place the mounting plate on the surface
so that the tab is pointing down, and mark the pilot holes. Use a drill to insert the
anchors then line up the mounting plate with the pilot holes and drill screws in.