Full Product Manual
Spotlight Features:
Motion/Light Sensor: The light instantly turns on when
it detects motion from up to 30 feet away. The light
sensor conserves battery life by preventing the light from
activating in daylight.
Auto Shut-o: Light shuts o automatically after
20 seconds if no motion is detected.
Bright LED: 500 lumens cover up to 800 sq ft.
Durable, Weather Resistant: Tight seals and UV resistant
material allow the light to work in all weather conditions.
Multiple Lights: Spotlights will activate simultaneously
when any spotlight within the network detects motion.
They will deactivate simultaneously if no motion is
detected in the group.
32333 Aurora Rd. Suite 100, Solon, OH 44139
877.298.9082
Installation Instructions
NetBright® High Performance Security Light
MBN3000
• 4 D-cell alkaline batteries
• 1 screwdriver (Phillips)
• 1 screwdriver (athead)
• Drill (1/4” drill bit for drywall installation)
• 3 screws & 3 anchors
• Mounting bracket
LED Light
LED Light
Motion & Light
Sensor
NOTE: Light sensor only allows light to activate in darkness. We recommend you test in a dark room or closet.
What you need to install:
What is included per light:
www.mrbeams.com
Tips:
•
Use only new alkaline D-Cell batteries with 1.5V rating.
•
Do not mix old and new batteries. If batteries are not new, it may cause the light to malfunction.
•
Install batteries with polarity in correct position.
•
Light may activate when batteries are inserted. Simply take light into a dark room,
allow batteries to settle, then test activation.
•
If your light will not turn o, it means that it is time to replace the batteries.
* 1 year limited warranty. Visit site for details.
* Visit our website to view installation video.
Battery Caution:
1) Do not mix old and new batteries
2) Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel cadmium) or
(nickel metal hydride) batteries
3) Do not dispose of batteries in re
4) Batteries should be recycled or disposed of as per state and local guidelines
3. Lift the battery lid o the back of the light. Insert 4
D-Cell batteries with the at ends against the springs.
1. To remove the back plate from the
light, use your nger to push up on the
mounting bracket tab. This will unlock
the bracket. Then slide the bracket
down o the back of the light.
7. Line up the light with the
mounting plate and slide the
light into the grooves.
4. Replace the battery lid and
make sure the screws are
twisted in tightly.
2. Use a screwdriver to loosen
the four screws on the back
plate. The screws will not come
out all the way.
5. Before mounting your light, test
the motion sensor in a dark closet or
bathroom. Close the light in the dark
room and leave for up to 5 minutes.
When you re-enter the room, the light
should activate with motion.
6. Determine mounting location for the
light. Place the mounting plate on the
surface so that the tab is pointing down
and mark the pilot holes for drywall.
Use a drill to insert the anchors, then
line up the mounting plate with the
holes and drill screws in.
Setting up lights to a network
After inserting the batteries, choose
a channel for your spotlights with
the dipswitches next to the battery
compartment. Ensure all units are on the
same channel by matching dipswitches.
* Lights set to the same channel that
are within 150 ft range of each other
will activate as one network. Light will
work with all other NetBright® lights
from Mr Beams®