Owner Manual

Stand Anywhere Light Features:
Motion/Light Sensor: Light instantly turns on when it
detects motion from up to 15 feet away. The light sensor
conserves battery life by preventing the light from
activating in daylight.
Auto Shut-o: Stick Anywhere Light shuts o
automatically after 20 seconds if no motion is detected.
Bright LED: 20 Lumens covers up to 20 sq ft.
600 Beta Drive, Unit 100, Mayeld Village, OH 44143
877.298.9082
Installation Instructions
Wireless Motion Sensor LED Stand Anywhere Light
MB750
• 4 AA-Cell Alkaline Batteries (per light)
• Wireless LED Stand Anywhere Light
LED Light
Motion & Light
Sensor
NOTE: Light sensor only allows light to activate in darkness. We recommend you test in a dark room or closet.
What you need to install:
Thank you for purchasing the Mr Beams
®
Stand Anywhere Light. We are committed to
eliminating darkness using the latest in
Light-Emitting Diodes (LEDs). LEDs are the most
ecient and durable light sources available. We
are certain that your light will contribute to a safer
environment and provide light where you need it at
a very reasonable cost.
What is included per light:
www.mrbeams.com
Tips:
•
Use only new alkaline AA-Cell batteries with 1.5V rating.
•
Do not mix old and new batteries. If batteries are not new, it may cause the light to malfunction.
•
Install batteries with polarity in correct position.
•
Light may activate when batteries are inserted. Simply take light into a dark room. Allow
batteries to settle, then test activation.
•
If your light will not turn o, it means that it is time to replace the batteries.
* 1 year limited warranty. Visit site for details.
* Visit our website to view installation video.
Battery Caution:
1) Do not mix old and new batteries
2) Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium)
or (Nickel Metal Hydride) batteries
3) Do not dispose of batteries in re
4) Batteries should be recycled or disposed of as per state and local guidelines
1. To open battery compartment, locate
the lid on the bottom of the light.
2. Twist the lid counterclockwise to unlock.
3. Lift the lid o the bottom of the light and
use your thumb to open the battery door.
5. Once the batteries have been inserted,
replace the lid by lining up the arrows and
turning until the arrow is pointing towards
the lock symbol.
4. Insert 4 AA-cell batteries with correct
polarity. Make sure the at ends of the
batteries are against the springs.
6. Test the motion sensor in a dark closet or bathroom.
Leave the light in the dark room for up to 5 minutes.
When you re-enter the room, the light should activate
with motion.