Operator`s manual

6
EN
6.1 STONE-GUARD ASSEMBLY
Attach the stone-guard by inserting the pin (1)
and the spring (2) as shown.
First, insert the pin into the right-hand hous-
ing (4). Next fit the eyelet end (3) of the
spring into the central slot, and lastly insert
the other end of the pin in place (5).
6.2 HANDLE ASSEMBLY
Intsert into the holes on the chassis
the lower part of the handle (1) and
lock into position with the screws (2)
provided, paying attention to screw
them correctly into the upper hole
Attach the upper part of the handle
(3) to the lower part (1) using the
knobs (4) and the screws provided,
as indicated.
Attach the cable clamp (5) in the
indicated position to fasten the cable
(6).
The correct position of the cable
hook (7-if foreseen) is as shown.
6. ASSEMBLY
4
3
5
1
2
3
1
3
5
6
7
1
4
2
7