User Manual

BREWING COFFEE NOW
1. After completing the steps in the Adding Water and Coffee
section and with the decanter and the filter basket securely
in place, turn the coffeemaker on by pressing the BREW NOW
button once (Figure 7). The BREW NOW light will turn on and
pulse to signal that the coffeemaker is on and brewing.
2. After the used coffee grounds have cooled, carefully remove the
filter basket and discard them.
NOTE: The brew basket drawer is hot after brewing. Always allow
the coffeemaker to cool down before cleaning.
3. Prior to making a second pot of coffee, turn the coffeemaker off. This will reset the
FRESH BREW™ TIMER feature. To turn the coffeemaker off, press the BREW NOW/OFF
button until all lights turn off.
4. Make sure the decanter is empty before starting to brew coffee.
5. Be sure to turn your coffeemaker off when no longer using it.
The Fresh Brew™ Timer Feature
The Fresh Brew™ Timer feature lets you know how long your coffee has been
waiting for you. At the start of the brew cycle, the Fresh Brew™ Timer feature will
automatically be activated. The timer will appear in the lower part of the display under
the clock (Figure 7). This display will be visible any time you are brewing coffee. The
display will change to show the time since brewing began in 15 minute intervals.
10 11
FIGURE 7
BREWING COFFEE LATER
1. You must first set the time for when you would like the
coffeemaker to begin brewing your coffee as described in
Setting the Clock and the Delay Brew Timer section.
2. Prepare your coffeemaker as described in Adding Water and
Ground Coffee section.
3. To activate the DELAY BREW function and program your
coffeemaker to brew coffee at a later time, press the DELAY
BREW button once. The coffeemaker is now set to automatically
brew coffee at the pre-set time (Figure 8).
4. At the pre-set time, the BREW NOW light will turn on and the DELAY BREW light will
turn off, indicating the brewing has started in the selected brew strength. The FRESH
BREW™ TIMER feature will start.
As a safety feature, your coffeemaker will NOT start again automatically the next
day. If you want your coffee to brew at the same time the following day, simply
add a new lter, coffee and water and set DELAY BREW, by repeating Steps 2 and
3 above.
NOTE: If the decanter is not in place then the coffeemaker will not brew.
To cancel DELAY BREW:
Press the DELAY BREW button until all lights turn off (Figure 8).
CLEANING AND MAINTAINING
YOUR COFFEEMAKER
Daily Cleaning
• Always unplug the coffeemaker and allow to cool before cleaning.
• Remove and wash the lter basket, permanent lter (not included on all models),
decanter and decanter lid in a solution of hot water and mild liquid soap.
• Never use abrasive cleansers, steel wool pads or other abrasive materials.
CAUTION! Never immerse the coffeemaker itself in water, in any other liquid
or place in the dishwasher.
Regular Cleaning and Maintenance
Your coffeemaker is equipped with a clean indicator/function. The Clean Function
is critical to optimize the performance of the coffeemaker. The clean function will
remove minerals (calcium/limestone) found in water that leave deposits in your
coffeemaker and affect its performance. Maintaining your coffeemaker will ensure that
it will continue to brew fast, hot and make great coffee.
Clean Function Indicator
Your Clean Indicator will illuminate when:
• Your coffeemaker has counted 90 brew cycles
OR
• Your coffeemaker experiences two consecutive brew cycles
lasting longer than 9.5 minutes
NOTE: The cleaning light will NOT turn off unless you run the
Cleaning Function in its entirety (this will take 45 minutes).
Clean Function
1. Fill reservoir with 6 cups of undiluted, white household vinegar*
2. Remove optional water filtration disk. Place empty paper filter
or permanent filter in brew basket
3. Place the empty decanter back in the unit.
4. Press the CLEAN button to activate the Cleaning Function (Figure 9).
a. When activated, the cleaning light will pulse and the Brew Now/Off button will
remain illuminated
b. A counter will be displayed on the LCD screen. The counter will begin at 45
minutes and will count down until it reaches zero indicating the cleaning cycle is
complete.
NOTE: The entire cycle will take 45 minutes to complete.
FIGURE 9
FIGURE 8