Operating Guide

13
Installation Instructions and Owner’s Manual
Unvented Liquid Propane Fired Room Heater
OBSERVED SYMPTOM POSSIBLE CAUSE REMEDY
Heater produces a whistling
noise when burner is lit
Turning control knob to HI position when
burner is cold
Turn control knob to LO position and let warm up for a minute
Air in gas line Operate burner until air is removed from line have gas line
checked by local gas company
Air passageways on heater blocked Observe minimum installation clearances (see Figure 4 page 6)
Dirty or partially clogged burner orifice Clean burner orifice (see Cleaning and Maintenance on page
11), or replace burner orifice
White powder residue
forming within burner box
or on adjacent walls or
furniture
When heated, vapors from furniture
polish, wax, carpet cleaners, etc., turn
into white powder residue
Turn heater off when using furniture polish, wax, carpet cleaner
or similar products
Heater produces unwanted
odors.
Heater burning vapors from paint,
hair spray, glues, etc. See IMPORTANT
statement on page 12
Ventilate room. Stop using odor-causing products while heater
is running
Gas leak. See WARNING statement at top
of page 12
Locate and correct all leaks (see Checking Gas Connections,
page 9)
Heater shuts off in use
(ODS operates)
Not enough fresh air is available Open window and/or door for ventilation
Low line pressure Contact local gas company
ODS/pilot is partially clogged Clean ODS/pilot (see Cleaning and Maintenance, page 11)
Gas odor even when
control knob is in OFF
position
Gas leak. See WARNING statement at top
of page 12
Locate and correct all leaks (see Checking Gas Connections,
page 9)
Control valve is defective Replace control valve
Gas odor during
combustion
Foreign matter between control valve
and burner
Take apart gas tubing and remove foreign matter
Gas leak. See WARNING statement at top
of page 12
Locate and correct all leaks (see Checking Gas Connections,
page 9)
Heater produces a clicking/
ticking noise just after
burner is lit or shut off
Metal expanding while heating or
contracting while cooling
This is common with most heaters. If noise is excessive, contact
qualified service person
Moisture/condensation
noticed on windows
Not enough combustion/ventilation air Refer to Fresh Air for Combustion and Ventilation page 3
through 5