Installation Guide

8
Mr. Heater | Portable Buddy Radiant Heater OperatingInstructionsandOwner’sManual
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
MAINTENANCE
Cleaning Instructions (Refer to
Exploded Parts on Page 10):
IMPORTANT: Allow heater to
thoroughly cool before performing any
maintenance.
1. Remove disposable 1 lb. cylinder
from heater or turn OFF gas supply at
remote cylinder valve, and disconnect
hose from heater.
2. Inspect interior of housing for
accumulation of dust, lint or spider
webs. If necessary, clean interior
housing with a vacuum cleaner or
apply air pressure. Do not damage
any components within the housing
assembly when you are cleaning.
3. Inspect and clean pilot (mounted to
bracket) by using a vacuum or apply air
pressure.
4. The exterior of the heater can be
cleaned with a damp cloth. Avoid the
direct use of any aerosol or spray-on
cleaners. Do not use abrasive materials
or cleaners on the decals or control
knob.
IMPORTANT: Users should not attempt
to repair or change any parts of the
heater. All repairs must be performed
by a qualified LP Gas Service Dealer or
at the factory. For additional assistance
or information, please call Technical
services at 800-251-0001.
OFFSEASON
• Iftheheateristoleft“OFF”fora
considerable period of time, the
propane (LP) gas supply to the heater
should be turned off as close to the
gas source as possible. In the case
of portable use, the gas should be
turned off at the propane (LP) gas
supply cylinder.
• If the heater is put into storage, make
sure to disconnect the propane (LP)
gas cylinder.
• When the LP-gas cylinder is not
disconnected from the heater, the
heater and cylinder must be located
outdoors, in a well-ventilated space,
out of the reach of children, and must
not be stored in a building, garage, or
any other enclosed area.
• Storage of the heater indoors is
permissible only if the cylinder is
disconnected and removed from
the heater. Cylinders must be stored
outdoors, in a well-ventilated space,
out of the reach of children, and must
not be stored in a building, garage, or
any other enclosed area.
WARNING: Never use needles,
wires or similar cylindrical objects to
clean the pilot to avoid damaging the
calibrated ruby that controls the gas
flow through the pilot orifice.