Manual

3
Operating Instructions and Owner’s ManualMr. Heater | Gas-Fired Infra-Red Portable Heater
HOOK-UP INFORMATION
1.1 Heater model MH15C is packaged completely assembled
except for metal stand. Propane cylinders are not included with
model MH15C.
1.2 Remove heater from carton.
1.3 Hold heater in one hand and with the other hand hold propane
cylinder vertically and carefully turn clockwise into heater valve-
regulator until snug. (Careful not to cross-thread) – Fig. 1
1.4 Use only LP-gas cylinders constructed for use with propane only
(HD-5) and marked in accordance with the specifications for LP-
gas cylinders of the U. S. Department of Transportation (DOT
Spec. 39).
1.5 Use propane fuel cylinders of not more than 75 cubic inches
(2-1/2 pounds nominal water capacity) and connect to cylinder
valve outlet connection No. 600 as specified in the Compressed
Gas Associations Limited Standard Cylinder Valve Outlet
Connection for propane-small valve series.
2.1 Grasp heater model by cylinder and hold wire stand with other
hand. Slide mounting clip on back of heater onto chrome
plated wire stand. Fig. 1.
2.2 Make sure wire stand is on a flat surface in the outdoors. See
paragraph 5 for additional assembly procedure.
2.3
WARNING
Never touch heater while in operation to avoid injury.
Move heater by grasping the propane cylinder carefully.
2.4 Read complete manual before lighting heater.
MODEL MH15C
Figure 1
3
VALVE/REGULATOR/#42112
PUSH BUTTON
SAFETY SHUTDOWN VALVE
CYLINDER - NOT SUPPLIED
WIRE STAND
THERMOCOUPLE
FACE GUARD
HEATER
RELECTOR