Operating instructions

ManualsBrandsMr. Heater ManualsElectric HeaterMH35LP

OPERATING INSTRUCTIONS

AND OWNER’S MANUAL

READ INSTRUCTIONS CAREFULLY: Read and follow all instructions. Place instructions in a safe

ace for future reference. Do not allow anyone who has not read these instructions to assemble,

lig

ht, adjust or operate the heater.

Model # MH35LP, HS35LP

04/03 Revision L1 #18675MR. HEATER INC., 4560 W. 160TH ST., CLEVELAND, OHIO 44135 • 216-881-5500

GAS-FIRED INFRA-RED

PORTABLE CONSTRUCTION HEATER

DO NOT LEAVE HEATER UNATTENDED OR IN OPERATION WHILE SLEEPING

WARNING: NOT FOR HOME OR RECREATIONAL VEHICLE USE

GENERAL HAZARD WARNING:

FAILURE TO COMPLY WITH THE PRECAUTIONS AND INSTRUCTIONS PROVIDED WITH THIS HEATER

CAN RESULT IN DEATH, SERIOUS BODILY INJURY AND PROPERTY LOSS OR DAMAGE FROM

HAZARDS

OF FIRE, EXPLOSION, BURN, ASPHYXIATION, CARBON MONOXIDE POISONING, AND/OR

ELECTRICAL SHOCK.

ONLY PERSONS WHO CAN UNDERSTAND AND FOLLOW THE INSTRUCTIONS SHOULD USE OR

RVICE THIS HEATER.

IF YOU NEED ASSISTANCE OR HEATER INFORMATION SUCH AS INSTRUCTION MANUALS, LABELS,

ETC., CONTACT THE MANUFACTURER.

WARNING:

FIRE, BURN, INHALATION AND EXPLOSION HAZARD. KEEP SOLID COMBUSTIBLES SUCH AS

BUILDING

MATERIALS, PAPER OR CARDBOARD A SAFE DISTANCE AWAY FROM THE HEATER AS

RECOMMENDED BY THE INSTRUCTIONS. NEVER USE THE HEATER IN SPACES WHICH DO OR MAY

CON

TAIN VOLATILE OR AIRBORNE COMPUSTIBLES OR PRODUCTS SUCH AS GASOLINE, SOLVENTS,

PAINT THINNER, DUST PARTICLES OR UNKNOWN CHEMICALS.

CYLINDER NOT INCLUDED

Serial Numbers 0 - 0117000

Summary of content (8 pages)

PAGE 1
Serial Numbers 0 - 0117000 OPERATING INSTRUCTIONS AND OWNER’S MANUAL Model # MH35LP, HS35LP READ INSTRUCTIONS CAREFULLY: Read and follow all instructions. Place instructions in a safe place for future reference. Do not allow anyone who has not read these instructions to assemble, light, adjust or operate the heater.
PAGE 2
VENTILATION SPECIFICATIONS MODEL NO. ......... MH35LP HS35LP WARNING GAS TYPE ................ LP-Gas MAX. INLET PRESSURE. .......... 22 in. w.c. THIS APPLIANCE IS UNVENTED AND MUST BE USED ONLY IN A WELL VENTILATED AREA. MIN. INLET PRESSURE ........... 22 in. w.c. The flow of combustion and ventilation air must not be obstructed. DO NOT use in a tightly enclosed area. Any combustion process requires and consumes oxygen, and may produce carbon monoxide.
PAGE 3
GENERAL INFORMATION A. Your Enerco/MR. HEATER portable gas-fired infra-red heater comes fully assembled and is tested at the factory for proper gas and input as stated on the nameplate. B. Each heater is equipped with a 100% safety shutoff, push button valve which will automatically stop the flow of gas in the event the heater fails to operate for any reason. A tip over switch and an excess flow check are also standard on the model MH35LP / HS35LP. C.
PAGE 4
The connection of Model MH35LP/HS35LP to an LP-Gas cylinder must be made in a well ventilated area using the regulator and hose assembly supplied with the appliance. DO NOT attempt to adjust this regulator. It has been preset at the factory to provide safe and proper operation of the appliance. Use a 7/8” open end wrench to connect the POL fitting (supplied with the LP regulator) to the LP-Gas cylinder. Turn the POL nut in a counterclockwise direction (left hand thread) until tight.
PAGE 5
TROUBLESHOOTING INFORMATION: (Model MH35LP/HS35LP) Shut-down instructions: To turn the heater OFF: If burner lights, but goes out when button is released. 1. Close the LP-Gas supply cylinder valve. 2. Observe the burner until flame is extinguished. CHECK 3. Listen for closure of the safety valve. • Loose wires on tipover switch. (see Fig. 4) 4. IMPORTANT: DO NOT re-open the LP-Gas supply cylinder valve before the safety valve closes. • Loose lead wire and repair wires if necessary.
PAGE 6
Tip Over Switch Magnetic Portion of Control Thermocouple Tip Over Switch Leads Adaptor Leads Control Junction Block Adaptor Kit Heater Bottom Figure 4 REPLACEMENT PARTS LIST Tip-Over Switch Arrangement REF. # ...... ITEM# NOTE: The purpose of the tip-over Switch is to stop the flow of gas when heater is accidentally knocked over. When and if the heater is knocked over, simply stand heater up. DESCRIPTION 1 .............. 00333 ......... CONT M-N SS PORT 3/8MPXI/4MP 2 .............. 02455 ........
PAGE 7
Mr. Heater/Enerco • Gas-Fired Infra-Red Portable Construction Heater • Model # MH35LP, HS35LP 14 3 2 10 4 5 13 9 11 6 15 1 12 7 8 IF SERVICE IS REQUIRED PLEASE DO NOT RETURN THIS APPLIANCE TO YOUR STORE For information regarding service, please call our Toll-Free Number: 1-800-251-0001. Our office hours are 8:30 AM to 5:00 PM, Eastern Time Zone, Monday through Friday Please include the model number, date of purchase and description of problem in all communication. Enerco |Mr.
PAGE 8
OPERATING INSTRUCTIONS AND OWNER’S MANUAL Model # MH35LP, HS35LP WARNING: USE ONLY MANUFACTURER’S REPLACEMENT PARTS. USE OF ANY OTHER PARTS COULD CAUSE INJURY OR DEATH. REPLACEMENT PARTS ARE ONLY AVAILABLE DIRECT FROM THE FACTORY AND MUST BE INSTALLED BY A QUALIFIED SERVICE AGENCY. PARTS ORDERING INFORMATION: PURCHASING: Accessories may be purchased at any Mr. Heater or Enerco local dealer or direct from the factory FOR INFORMATION REGARDING SERVICE Please call Toll-Free 800-251-0001 www.mrheater.