Operating instructions

ManualsBrandsMr. Heater ManualsOtherMHGLLP B

OPERATING INSTRUCTIONS

AND OWNER’S MANUAL

READ INSTRUCTIONS CAREFULLY: Read all information and instructions, including gaslamp

Warning Tag attached to light, before installation or use. Retain this guide for future reference.

MHGLLP B

MHGLLP G

Model #

08/08 20362 Rev. L1ENERCO GROUP, INC., 4560 W. 160TH ST., CLEVELAND, OHIO 44135 • 800-251-0001

If the information in this manual is not followed exactly, a ﬁre or explosion

may result causing property damage, personal injury or loss of life.

WARNING:

— Do not store or use gasoline or other ﬂammable vapors and liquids in the vicinity of this or any

other appliance.

— FOR YOUR SAFETY

If you smell gas:

 • Shutoffgastotheappliance.

 • Openwindows.

 • Don’ttouchelectricalswitches.

 • Extinguishanyopename.

 • Immediatelycallyourgassupplier.

— Service must be performed by a qualiﬁed service agency.

Attention installer:

C.S.A. regulations require that you leave these instructions with the appliance for the consumer.

INDOOR GASLAMP

Operational Instructions Only - No Parts List

Summary of content (8 pages)

PAGE 1
Operational Instructions Only - No Parts List Operating Instructions and Owner’s Manual Model # MHGLLP B MHGLLP G READ INSTRUCTIONS CAREFULLY: Read all information and instructions, including gaslamp Warning Tag attached to light, before installation or use. Retain this guide for future reference. INDOOR GASLAMP WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
PAGE 2
WARNING: WARNING: Every time tank is connected to unit, connection must be checked for leaks in one or more ways: Apply soapy water to connection, look for bubbles, listen for hiss of escaping gas, feel for extreme cold, smell for rotten egg odor. Do not use if leaking! Use your gaslamp in vented rooms only. Carbon monoxide is produced by the incomplete combustion of fuel. WARNING: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
PAGE 3
Installation & ASSEMBLY 3. Connect approved copper tubing to gas inlet using proper fitting. It is easier to connect the tubing before fastening wall bracket assembly to wall. Valve assembly (Ref. #2) must be straight on the wall bracket assembly. Orifice (Ref. #4) must aim into the center of the Bunsen Burner Venturi (BBV) (Ref. #28) for proper air and gas mixture. A knockout tab (twist out using pliers) in the valve cover is provided for connecting the gas line through the bottom of the valve cover. 4.
PAGE 4
b. Tie-on mantle: Loop the tie-on strings at the opening of the mantle. Enlarge the opening so that it will fit over the ceramic burner head and seat in lower groove of burner head. Do not tie the mantle to the BBV. Distribute mantle evenly around the burner head. Pull the ends of the string so that mantle and string are seated securely in the burner head groove. Knot and clip off excess string. LIGHTING GAS Lamp C. Replace globe.
PAGE 5
Orifice All gaslamps are equipped with standard propane orifices. To use gaslamps at elevations of 4500 feet or more above sea level, order High Altitude Orifice, #20368 for propane gas. Bunsen Burner Venturi (BBV). Unobstructed flow of combustion air and ventilation air must be maintained. To ensure proper air flow and gas mixture, the inside of the BBV must be clean and free of any obstruction. Make a periodic visual check of the BBV.
PAGE 6
Mr.
PAGE 7
This Page Intentionally Left Blank Mr.
PAGE 8
Operating Instructions and Owner’s Manual Model # MHGLLP B MHGLLPG WARNING: USE ONLY MANUFACTURER’S REPLACEMENT PARTS. USE OF ANY OTHER PARTS COULD CAUSE INJURY OR DEATH. REPLACEMENT PARTS ARE AVAILABLE FROM MR. HEATER LOCAL DEALER OR DIRECT FROM THE FACTORY AND MUST BE INSTALLED BY A QUALIFIED SERVICE AGENCY. PARTS ORDERING INFORMATION: PURCHASING: Accessories may be purchased at any Mr.