Operation Manual

Select “Start Wifi setting” and press “Scan”. The system is now going to search for local Wifi connections. When the

scan is finished please select your local Wifi in the “Network name (SSID)” box. Type your network password and click

“OK”. After confirming, the IP camera will automatically restart. This can take a few minutes. The camera is now

connected to your Wifi. That means that you can unplug the network cable after the Wifi connection is tested and

move the camera to another location within the Wifi range.

After you have set the Wifi (as described below), you should first check if the camera is functioning properly when it

is placed close to the modem. If that is the case, you must place the camera at the desired location and take a few

days to check if on that location the Wifi connection remains stable, and if the Wifi signal is always strong enough. If

this is the case, you can mount the camera permanently. If the connection is not stable, you should look for a location

closer to the modem, connect to a network or install a Wifi repeater between the camera and the Internet modem.

5. LAN CAMERA

All the cameras that are online in your local network (LAN) will be displayed in the LAN list. The color of the camera

icon next to the name of the camera (CAM ID) will change depending on the status of the camera:

• Gray: Camera not available (offline)

• Blue: Camera available (online)

• Red: Camera is activated and viewed

5.1. LAN Camera browsing

Go to the LAN list and double click on the camera you want to see. The program is now going to make contact with

your IP camera. This can take a few seconds.