Installation Guide

mr
.
steam
®
Operating Instructions
________________________________________________________________________________________________
13
SETTING THE TEMPERATURE
Diagram 3: Press TEMP key to set the desired temperature or display the temperature setting. The control
is preset and will display a temperature setting of 110˚F (default setting). With the temperature displayed,
press the LEFT or RIGHT arrows to set the desired temperature (80°F to 120°F) in one degree increments.
Set the steam bathing temperature according to personal preference, however it is highly recommended
to begin steam bathing at a low temperature setting to gauge comfort and safety levels.
MEMORY FEATURE
If the control is turned off manually before it times out then the default settings of 20 minutes and 110°F
will be used the next time the control is turned on. If the control times out (not manually turned off) then
the previous user time and temperature settings will be used when the steambath is turned on.
USER PRESETS Diagram 4
Use the key program to store preferred settings.
To program preferred settings:
Press ON/OFF key to turn generator on. Press key once to program PROG1.
Press it twice to program PROG2. The selected setting will be displayed.
Enter the preferred time and temperature settings.
The AirTempo will store the following settings: Set point, Time duration & Aroma state.
To select PROG1 or PROG2:
Press ON/OFF key then press key once to select PROG1, press it twice to select PROG2.
The steambath will operate at the stored settings.
Diagram 3
Diagram 4
TEMP
Time &
Temperature
adjustment
User Preset