Installation Sheet

mr
.
steam
®
Installation Instructions
________________________________________________________________________________________________
12
The AirTempo features programmable temperature
control, programmable time duration, AromaSteam
ON/OFF, ChromaSteam
®
control and two personal
settings.
The LCD will be OFF until a button is pressed. The
LCD remains lit for 10 seconds after the last button
is pressed. When the steam generator turns OFF
the display will turn on and read OFF. While the
generator is steaming the LED above AROMA and
CHROMA will alternately ash every 2 seconds.
Set the steam bathing temperature
according to personal preference, however it is
highly recommended to begin steam bathing at a
low temperature setting for a very short duration to
gauge comfort and safety levels.
AirTempo Operating Instructions
Diagram 1
Diagram 2
ON/OFF
Time
WARNING
!
ON/OFF Diagram 1
Press the ON/OFF key for 1 second to start the
ow of steam. The Temperature Set Point is
displayed. Steam will begin to ow a few minutes
after the control is turned ON. The duration re-
quired for the steam room to reach steam bathing
temperatures depends on the steam room
construction and steam generator specifications.
To stop the ow of steam before time expires press
the ON/OFF key. Steam may continue to ow
for a short time after the control is turned OFF
SETTING THE STEAMBATH DURATION
Diagram 2
Press TIME key to set or display the steambath
duration time. The control is pre-set and will display
a TIME setting of 20 minutes (default setting).
With the TIME displayed, press the LEFT or RIGHT
arrows to set the desired duration time (2-60
minutes) in two minute increments.