AudioSteam Installation Sheet

Connecting the FM Antenna
and Auxiliary Cord
1. Plug the included FM antenna into the antenna
output and route the wire through the strain relief
channel as illustrated (Figure 9). For best recep-
tion, fully deploy the antenna in a vertical orienta-
tion outside of the AudioSteam housing.
2. Connect a 1/8” (3.5 mm) stereo audio cord (not
included) to the auxiliary output, and route the
cable through the strain relief channel as illus-
trated (Figure 9). Connect the free end of the
audio cord to a mobile device or digital music
player.
Connecting Speakers
and Subwoofer
1. Connect individual speaker wires — or a 10-pin
MATE-N-LOK adapter with attached wires — to
the speaker outputs. Refer to Figure 10 and
Figure 11 for connector identification.
2. Route the wires through the molded relief chan-
nel. Connect the speaker wires to suitable speak-
ers and subwoofer.
3. Replace the foam block inserts (Figure 9).
4. Secure the cover using the two cover screws.
9
10 9 8 7 6 5 4 3 2 1
Figure 10
Figure 11
Figure 9
Auxiliary
Cord
FM
Antenna
Route
Wires
Replace
Foam
Blocks
CONNECTION IDENTIFICATION COLOR
1 Front Left speaker (+) White
2 Front Left speaker (-) White/Black
3 Front Right speaker (-) Grey/Black
4 Front Right speaker (+) Grey
5 Rear Left speaker (+) Green
6 Rear Left speaker (-) Green/Black
7 Rear Right speaker (-) Purple/Black
8 Rear Right speaker (+) Purple
9 Subwoofer (+) Blue
10 Subwoofer (-) Blue/Black
IMPORTANT NOTES
• If you use individual speaker wires, the rec-
ommended socket crimping contact is an
AWG 14-20 (TE Connectivity part number
350550-3).
• If you use a 10-pin MATE-N-LOK adapter
with attached wires, the required hous-
ing connector is a 10-position Universal
MATE-N-LOK (TE Connectivity part number
926302-3).
mr
.
steam
®
INSTALLATION, OPERATION, AND MAINTENANCE AudioSteam
®
All drawings are for illustrative purposes only.
AudioHome only uses positions 1, 2, 3 & 4
INSTALLER