Installation Guide

ManualsBrandsMr. Steam ManualsBath9kW Steam Bath Generator with iSteam3 AutoFlush Package in Black

steam

INSTALLER INFORMATION

__________________________________________________________________

STEP 2

Peel the double stick adhesive off the back of the

iSteam3 control (2a). Apply a bead of silicone around

the rear of the iSteam3 control to create a moisture

seal (2b). Carefully feed the cables into the rough-in

box and secure the control to the wall. Care must be

taken to not pinch the cables. Ensure the control is

level.

IMPORTANT NOTE:

The control must be installed

with the arrow on the Peel-Off screen protector facing

up. If the Peel-Off screen protector has been removed

see the drawing in Step 2b for the proper orientation.

The control display can be ﬂipped 180 degrees in the

settings menu if installed upside down.

NOTE: The silicone supplied by MrSteam can be

used to meet a variety of sealing and gasketing. It

cures to silicone rubber and adheres to glass, wood,

metal, porcelain, ceramic tile, painted surfaces, many

plastics and rubber. Surfaces must be clean and dry.

Apply thin layer of product. Fit together and support

if necessary. Allow excess material to cure, then trim

with a sharp blade. Sealant “skins” in 5 minutes, dries

to touch in 1 hour. Fully cures and bonds in 24 hrs.

IMPORTANT NOTE: Do not apply excessive amounts

of silicone. Do not apply silicone to any other parts

of the control including the adhesive gasket. Insure

the mounting surface is clean and dry as required for

good adhesion. Hold the control with the arrow on

the screen protector facing up and press the control

against the wall u ntil the adhesive sticks and holds

ﬁrmly. Control may have to be supported or secured

until the silicone has cured for 24 hours.

1 2 : 1 6

P M

S T A R T

9 7

2 : 1

S T A R

Installation Instructions for iSteam

3 (cont.)

This

End

Before use, remove

and discard the peel-

off screen protector.

This

End