Installation Guide

ManualsBrandsMr. Steam ManualsBath9kW Steam Bath Generator with iSteam3 AutoFlush Package in Black

LOCATING THE STEAM GENERATOR

Select a location as near as practical to the steam room. Typical locations include: closet, vanity cabinet,

heated attic or basement.

NOTE:

The standard length of the cable for connecting the control to the steam generator is 30 feet. The steam generator and

control must be located accordingly. A 60 foot cable is available as a special order part for iTempo

and AirTempo

PN 103990-60 and PN 104117-60 for iSteam

The maximum cable length is 60 feet.

IMPORTANT NOTE: The control cable should be run in a dedicated 1" conduit to facilitate installation and service.

DO NOT route iSteam, AirTempo, iTempo/Plus, iTempo, HomeWizard or iGenie control wiring inside conduit

together with power lines or close to hot water or steam piping. Doing so may result in an inoperative or hazardous installation.

(Items 1-5)

1. DO NOT

install steambath generator inside steam room,

a shock hazard will occur.

2. DO NOT

install steambath generator outdoors or

wherever environmental conditions may result in a

shock hazard or affect performance of the generator.

3. To prevent damage to the steam generator or a fire

hazard DO NOT

install steambath generator near

flammable or corrosive materials or chemicals such as

gasoline, paint thinners, or the like. Installation in areas

having high concentrations of chlorine (such as pool

equipment room) must be avoided.

4. Burn Hazard. Steam line, safety valve, drain valve and

plumbing become hot during operation and remain

hot after shutdown for a period of time. Provide

appropriate protection, including insulating plumbing

lines. Avoid plumbing runs and steamhead locations

that can come in contact with bathers.

5. Suitable for operation in ambient not exceeding 45 °C

(113˚ F). Operation of the steam generator in an ambient

temperature above 45 *C (113 *F) may result in a

hazardous condition or property damage

(Items 6-8)

DO NOT

install steambath generator or plumbing lines, in

unheated attic or any locations where water could freeze

and cause pipes to rupture and cause property damage.

7. Install steambath generator on a solid and level surface.

Keyhole slots are provided for wall mounting. Insure the

steam generator is properly secured and level when

mounting with keyhole slots to prevent damage to the

steam generator.

8. Install steambath generator in an upright position only

to prevent damage to the generator.

IMPORTANT NOTES: (Items 9-13)

9. Install anti-water hammer device as necessary.

Provide a minimum of (12) inches at both ends and top of

the steam generator or as required for servicing. See page 8.

11.

Provide unions as required to facilitate installation

and disconnection of piping.

. MrSteam controls can be located inside the steam room

or on the outside of the steam room. See the Control

Installation Manual for your specific control package for

specific details.

13. The MS series of steam generators are for residential use

only. Commercial or other nonresidential applications

void the warranty and may adversely affect product

performance and may represent a safety hazard.

NOTE:

MrSteam Generators (inclusive of the iTempo, AirTempo

and iSteam series controls) are CE and UL listed.

WATER QUALITY INFORMATION

For optimum results, the water supply should be tested prior

to installation. If the mineral content exceeds the following

recommended limits, various external treatment processes are