iTempo Installation Manual

mr
.
steam
®
Installation & Operating Instructions
______________________________________________________________
8
DIAGRAM 6
Drawings for Illustrative Purposes Only.
STEP 6 Diagram 5
Run a bead of silicone (provided) as shown
to the outer edge of the control faceplate,
following the contour of the circle or square
shape. Use silicone as required to create a
moisture seal.
NOTE: The silicone supplied by Mr. Steam
can be used to meet a variety of sealing and
gasketing. It cures to silicone rubber and
adheres to glass, wood, metal, porcelain,
ceramic tile, painted surfaces, many plastics
and rubber. Surfaces must be clean and dry.
Apply thin layer of product. Fit together and
support if necessary. Allow excess material
to cure, then trim with a sharp blade.
Sealant “skins” in 5 minutes, dries to touch
in 1 hour. Fully cures and bonds in 24 hrs.
IMPORTANT NOTE: Do not apply
excessive amounts of silicone. Do not apply
silicone to any other parts of the control
including the adhesive gasket.
STEP 7 Diagram 6
Insure the mounting surface is clean and
dry as required for good adhesion. Hold
the control with the LED display in the
12 o’clock position and press the control
against the wall u ntil the adhesive sticks
and holds firmly. Control may have to be
supported or secured until the silicone fully
cures and bonds.
DIAGRAM 5