AirTempo Installation Manual

steam

Installation Instructions

________________________________________________________________________________________________

Silicone Sealant

Cable

Wall

⁄4" minimum

⁄2"

maximum

5. Route the end of the probe cable with the temperature probe

through the wall into the steam room as shown in Diagram 2.

IMPORTANT NOTE: Do not strain, staple, pinch or otherwise

damage the probe cable.

6. With a minimal length of the cable exposed apply silicone

(provided) to the hole in the wall as required to create a mois-

ture seal as shown in Diagram 2.

7. Push the temperature cable and probe into hole as required to

leave minimum 1/4”, maximum 1/2” of the bulb exposed as

shown.

WARNING

Sectional View

steam room

interior

Diagram 2

Insure a minimum of 1/4” of the temperature probe is exposed

to the air. Failure to do so may interfere with the ability to sense tempera-

ture and may result in excessive steam room temperatures.

The exposed area of the temperature probe must be free of

silicone or any materials or obstructions that prevent direct exposure to the

steam room air. Failure to do so may interfere with the ability to sense tem-

perature and

may result in excessive steam room temperatures

NOTE:

For Illustrative Purposes Only. Drawings Not to Scale

Installed Remote Temperature Probe

showing a minimum of 1/4” of the probe

exposed to steam room air