Installation Guide

READ ME FIRST!
(cont.)
Linear Steam Head
®
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Installation Instructions: Model 104216
mr
.
steam
®
2
NOTE: Drawings are for illustrative purposes only. Consult with qualified designer, architect or contractor for steam room construction.
2
1
/
4
”
Round
Mounting
Holes
5
/
8
”
7
1
/
2
”
Slotted
Mounting
Holes
2
”
Steam
Outlet
14
1
/
8
”
3
/
4
”
NPT Steam
Outlet Connection
12
1
/
8
”
Figure 1
• DO NOT use black iron pipe or galvanized pipe for the
steam line. Use brass pipe or copper tubing only, and
in accordance with national and local plumbing codes.
• Do not modify or alter the steam head. Do not cover,
block or insert any product that is not a MrSteam
supplied product into the steam outlet. Failure to
follow these instructions may result in a leak within the
wall cavity, or result in a hazardous condition and/or
personal injury.
IMPORTANT NOTES:
• See the Installation and Operation Manual provided
with the steam generator for additional important
installation and operation information. If this
installation and operation manual is not available then
go to www.mrsteam.com for an online copy, or
contact MrSteam Customer or Technical Services at
800-767-8326 or 800-727-8326 for a free copy.
• Do not disassemble the steam head. The steam head
is shipped fully assembled and requires no additional
assembly. Failure to follow these instructions may result
in a leak within the wall cavity and cause problems
associated with leaks, moisture and property damage
from leaks.
• Consult with supplier of acrylic, fiberglass and other
non-heat resistant enclosures for elevated temperatures,
steam, and moisture compatibility. Consult with supplier
of acrylic, fiberglass and other non-heat resistant
enclosures for recommended steam head locations.
• To prevent damage to property do not locate the steam
head where steam, elevated temperatures, moisture or
water can contact any products, wall surfaces, materials,
door seals, devices, electronics that are not designed
for steam, elevated temperatures, moisture or water.
• Do not use abrasive cleansers or chemicals to clean
the steam head. Use only water with mild soap and a
non-abrasive sponge. The use of abrasive cleansers
or chemicals will damage the finish on the Linear
Steam Head.
BOX CONTENTS:
• Linear Steam Head
• Silicone Sealant
• Installation Instructions
Number Steam
Generator of Linear Emission
Model Steam Heads Zone
MS90 – MS400 1 18”
Super1 – Super3 1 24”
MX4 – MX6 2 24”
CT6, CT9 1 18”
CT12, CT15 1 24”
CAUTION
!