Installation Sheet

steam

Installation & Operating Instructions

_________________________________________________________________

Drawings for Illustrative Purposes Only.

SETTING THE CLOCK

Diagram 3

When the display is not ﬂashing: Press and hold the

TIME key until the display starts ﬂashing.

Use the UP/DOWN keys to select the desired time,

at this time the AM/PM logo will be displayed.

Press the TIME key to save changes.

SETTING THE STEAMBATH DURATION

Diagram 4

Press TIME key to set or display the steambath

duration time on the clock. The control is pre-set

and will display a TIME setting of 20 minutes (de-

fault setting). With the TIME or CLOCK displayed,

press the UP or DOWN keys (Diagram 5) to set the

desired duration time (2-60 minutes) in two minute

increments.

Set the steambath duration according to personal

preference, however it is highly recommended to

begin steam bathing at a very short duration to

gauge comfort and safety levels. The control will

turn off when the duration period times out. Then,

the clock time will be displayed.

DIAGRAM 3

DIAGRAM 4

DIAGRAM 5

mr.steam

temp

aroma