Owners Manual

LOCATING THE iSTEAM
®
3,
iTEMPO
®
, iTEMPO/PLUS
®
& AIRTEMPO
®
CONTROLS
Locate control (or Remote Temperature Sensor) where it will
sense general room temperature and NOT direct steam emission
from the steam head.
Controls installed inside the steam room must be located 4-5 feet
above the  oor on a vertical wall.
Locating any control outside of the steam room will require the
installation of a Remote Temperature Sensor inside the steam
room (see page 13).
WARNING The information in this guide is designed to provide a general overview of how MrSteam® products are installed. All images and diagrams are for illustrative purposes only
and may have been altered for presentation purposes. NEVER use this document for the Installation, Operation or Maintenance of any MrSteam® product. For installation, operation and
maintenance information and instructions, only use the applicable MrSteam® Installation, Operation & Maintenance Manual(s). The specific Installation, Operation & Maintenance manual
that is supplied with each MrSteam® product contains important information required for the safe and reliable installation and operation of the product. Failure to install any MrSteam®
product according to the applicable manual may result in property damage, an inoperable system/control, or hazardous condition. If you do not have the applicable Installation, Operation
& Maintenance manual please contact MrSteam® for a free copy, or download a copy from www.mrsteam.com. If you have any questions about the installation, operation or maintenance of
any MrSteam® product please contact a customer or technical service representative using the contact information on the back cover of this guide or consult a properly licensed contractor,
architect and/or design professional.
iSTEAM
®
3
iTEMPO/PLUS
®
AIRTEMPO
®
CAUTION: TO AVOID UNINTENTIONAL
STEAM BATH OPERATION, DO NOT LOCATE
THE CONTROL WHERE OTHER CONTROLS,
ACCESSORIES, SHOWER HEADS, VALVES, BODY
SPRAYS OR SIMILAR WITHIN THE SHOWER
COULD CAUSE CONFUSION OR INTERFERE
WITH THE MRSTEAM CONTROL’S INTENDED
USE AND FUNCTION.
RUN CABLE THROUGH
CONDUIT INSIDE WALL CAVITY.
CABLE NOT REQUIRED
WITH AIRTEMPO
®
.
15
MRSTEAM
®
GUIDE