Specification Sheet

ManualsBrandsMr Steam ManualsSteam Shower KitsMr Steam Butler Max Linear Steam Shower Package - Less Generator

INSTALLATION STEPS

Because steam emissions are very hot,

locate the steam head where incidental contact by

the bather with direct steam emission cannot occur.

Do not locate the steam head in any location where

the steam emission zone is near a seat, bench or any

space occupied by any persons. See Fig. 2 for a

diagram of the steam emission zone. Failure to follow

these instructions may result in a hazardous condition,

scalding or personal injury.

Do not install a Linear Steam Head in a

tub or acrylic/fiberglass shower enclosure. Failure to

follow these instructions may result in a hazardous

condition, scalding or personal injury

STEP 1.

Locate the steam head 6-12” above the

finished floor. Do not locate the steam head in any

location where the steam emission zone is near a seat,

bench, or any space occupied by any persons. See

Fig. 2 for a diagram of the steam emission zone.

STEP 2.

Confirm proper stud spacing: The studs must

have a minimum spacing of 14-1/8” and a maximum

spacing 14-1/2 “. If the stud spacing is outside the

required range then shim or otherwise reposition the

studs as required.

Installing the steam head between

incorrectly spaced studs may result in damage to the

steam head and result in a leak within the wall cavity

and cause property damage.

STEP

3. Determine the location of the finished wall

surface. Mount the steam head between two studs

using the four slotted holes to position the steam

outlet face to be flush or extend 1/8” from the

finished wall surface (see Fig. 4).

Failure to position the steam head face

to be flush or extended 1/8” from the finished wall

surface may result in a leak within the wall cavity and

cause problems associated with leaks, moisture and

property damage from leaks.

STEP

4. Use a level to ensure the steam head is level

(see Fig. 3 ) and the steam head face is flush or

extends 1/8” from the finished wall surface. Install the

four screws in the mounting holes to secure the steam

head to the studs.

Linear Steam Head

–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––

Installation Instructions: Model 104216

steam

NOTE:

Drawings are for illustrative purposes only. Consult with qualified designer, architect or contractor for steam room construction.

Copper Tubing

or Brass Pipe

(not provided)

Steam Outlet

Threaded

Adaptor or

Thread Plug

as required

(not provided)

Stud

Level

” – 14

”

Figure 3

CAUTION

Steam

head

6”-12”

above

floor

STEA M

EMIS SION

ZONE

Steam Room

Interior

STEA M

EMIS SION

Figure 2

CAUTION