Specification Sheet

ManualsBrandsMr Steam ManualsSteam Shower KitsMr Steam Butler Max Linear Steam Shower Package - Less Generator

Linear Steam Head

–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––

Installation Instructions: Model 104216

steam

NOTE:

Drawings are for illustrative purposes only. Consult with qualified designer, architect or contractor for steam room construction.

• Complete steam room tile construction information is available from the Tile Council of America, Inc. by

purchasing the TCA Handbook for Ceramic Tile Installation. 864- 646-8453 or www.tileusa.com.

Information on marble steam room construction is available from the Marble Institute of America www.marble-

institute.com. Failure to follow these instructions may result in damage to tile, marble or other materials.

• Finished wall surface may be tile, marble, granite or other steam rated surface.

• MrSteam is not responsible for the steam room construction.

• Consult with qualified designer, architect or contractor for steam room construction.

For Installation assistance please call Customer or Technical support:

East Coast 1-800-767-8326 • West Coast 1-800-727-8326

To view an installation video please go to: www.mrsteam.com

This video is for added visual assistance only. Do not install the Linear Steam Head using the video.

Use only these installation instructions for a safe and problem free installation.

Figure 4

STEP

5. Plumb rigid copper tubing or brass pipe from the

steam generator to the steam head. Plumbing must not form

traps or valleys. Thread sealant must be used as required to

ensure a leak free joint.

• Plumbing must be installed by a qualified and licensed

plumber. Plumbing in a manner that results in traps or

valleys in the pipe may result in a noisy or inoperable

installation.

• Plumbing without proper thread sealant may result in a

leak within the wall cavity and cause problems associated

with leaks, moisture and property damage from leaks.

• DO NOT use black iron pipe or galvanized pipe for the

steam line. Use brass pipe or copper tubing only, and in

accordance with national and local plumbing codes.

STEP

6. Run the steam generator for a few steam cycles to

observe and verify that the steam head, steam head

installation and plumbing are correct and free of leaks.

STEP

7. Insulate steam line and steam head using insulation rated 212°F

or higher. Insulate the steam head and piping as required to reduce

temperatures within the wall cavity. DO NOT locate the steam head or

plumbing near any materials, including wiring, devices, or products that may

be adversely affected by elevated temperatures. Failure to follow these

instructions may result in the failure of materials, including wiring, devices,

or products.

STEP

8. After the finished wall surface has been installed use high

temperature caulking around the steam outlet as required to make a

waterproof seal. (see Fig. 4)

STEP

9. A plastic protective film has been provided to protect the steam

head during installation. Remove the plastic protective film covering the

steam outlet to complete the installation.

CAUTIONS

Cement Board

Thin Set

Finished

Wall Surface

Steam Outlet Face

Silicone

STUD

Flush to

”