Owners Manual

STEP 2
Peel the adhesive  lm off the back of the iSteam
control (2A). Apply a bead of silicone (provided)
around the rear of the control as required to create
a moisture seal (2B).
Ensure the control is level. Carefully feed the cable
into the rough-in box and secure the control to the
wall. Care must be taken to not pinch the cable.
Remove and discard the peel off screen protector
(2C).
WARNING The information in this guide is designed to provide a general overview of how MrSteam® products are installed. All images and diagrams are for illustrative purposes only
and may have been altered for presentation purposes. NEVER use this document for the Installation, Operation or Maintenance of any MrSteam® product. For installation, operation and
maintenance information and instructions, only use the applicable MrSteam® Installation, Operation & Maintenance Manual(s). The specific Installation, Operation & Maintenance manual
that is supplied with each MrSteam® product contains important information required for the safe and reliable installation and operation of the product. Failure to install any MrSteam®
product according to the applicable manual may result in property damage, an inoperable system/control, or hazardous condition. If you do not have the applicable Installation, Operation
& Maintenance manual please contact MrSteam® for a free copy, or download a copy from www.mrsteam.com. If you have any questions about the installation, operation or maintenance of
any MrSteam® product please contact a customer or technical service representative using the contact information on the back cover of this guide or consult a properly licensed contractor,
architect and/or design professional.
2A
2B
2C
18MRSTEAM
®
GUIDE