Owners Manual

ManualsBrandsMr Steam ManualsPlumbingIButler Max Linear Steam Generator Control Kit / Package

WARNING The information in this guide is designed to provide a general overview of how MrSteam® products are installed. All images and diagrams are for illustrative purposes only

and may have been altered for presentation purposes. NEVER use this document for the Installation, Operation or Maintenance of any MrSteam® product. For installation, operation and

maintenance information and instructions, only use the applicable MrSteam® Installation, Operation & Maintenance Manual(s). The specific Installation, Operation & Maintenance manual

that is supplied with each MrSteam® product contains important information required for the safe and reliable installation and operation of the product. Failure to install any MrSteam®

product according to the applicable manual may result in property damage, an inoperable system/control, or hazardous condition. If you do not have the applicable Installation, Operation

& Maintenance manual please contact MrSteam® for a free copy, or download a copy from www.mrsteam.com. If you have any questions about the installation, operation or maintenance of

any MrSteam® product please contact a customer or technical service representative using the contact information on the back cover of this guide or consult a properly licensed contractor,

architect and/or design professional.

AIRTEMPO

SURFACE MOUNT

INSTALLATION

STEP 1

Determine the desired installation location of the control.

The AirTempo controls are designed to be installed inside or

outside the steam room as a matter of personal preference.

STEP 2

• Remove the surface mount bayonet from the back

of the AirTempo Control (A).

• Remove and discard the release paper to expose the

adhesive liner (B).

STEP 3

• Ensure the mounting surface is clean,  at/smooth, and dry.

• Place the bayonet on the wall in the desired location

(on veritcal wall 4-5 feet above the  oor near the bather

seating area).

STEP 4

• Wait 15 minutes before placing the control on the

bayonet to ensure the adhesive is secured.

IMPORTANT NOTE: If the control is installed outside the steam

room, a Remote Temperature Probe (part number MSTS) must

be installed inside the steam room. See Remote Temperature

Sensor page 12.

Use the screw and anchor provided to secure the bayonet to the

wall as required for rough or uneven wall surfaces. The surface

mount bayonet supports the weight of the AirTempo

control.

4-5 ft

FLOOR

BAYONET

MRSTEAM

GUIDE