Owners Manual

WARNING The information in this guide is designed to provide a general overview of how MrSteam® products are installed. All images and diagrams are for illustrative purposes only
and may have been altered for presentation purposes. NEVER use this document for the Installation, Operation or Maintenance of any MrSteam® product. For installation, operation and
maintenance information and instructions, only use the applicable MrSteam® Installation, Operation & Maintenance Manual(s). The specific Installation, Operation & Maintenance manual
that is supplied with each MrSteam® product contains important information required for the safe and reliable installation and operation of the product. Failure to install any MrSteam®
product according to the applicable manual may result in property damage, an inoperable system/control, or hazardous condition. If you do not have the applicable Installation, Operation
& Maintenance manual please contact MrSteam® for a free copy, or download a copy from www.mrsteam.com. If you have any questions about the installation, operation or maintenance of
any MrSteam® product please contact a customer or technical service representative using the contact information on the back cover of this guide or consult a properly licensed contractor,
architect and/or design professional.
iTEMPO OR iTEMPO/PLUS
CONTROL INSTALLATION
STEP 1
Firmly connect the control cable to the control pigtail.
Turn on power to the steam generator and test
the control to verify correct connections. Test per
instructions.
Disconnect control cable. Make a 2-5⁄8” wide by 3-7⁄8”
high cutout in the desired control location.
STEP 2
Firmly connect control cable. Remove & discard peel-off
paper to expose adhesive liner.
STEP 3
Apply a bead of silicone (provided) around the rear of
the control as required to create a moisture seal.
STEP 4
Ensure the mounting surface is clean,  at/smooth, and
dry as required for good adhesion. Hold the control with
the LED display in the 12 o’clock position and press the
control against the wall until the adhesive sticks and
holds  rmly as shown.
IMPORTANT NOTE: Turn power to the steam generator OFF before installing the
control. Failure to turn the power off will result in an inoperable control.
23 MRSTEAM
®
GUIDE