Owners Manual

ManualsBrandsMr Steam ManualsPlumbingIButler Max Linear Steam Generator Control Kit / Package

REMOTE TEMPERATURE

SENSOR (MSTS)

A Remote Temperature Sensor

is required when the control is

installed outside the steam room.

Locate the RemoteTemperature

Sensor where it will sense

general room temperature and

NOT direct steam emission

from the steam head. Refer

to the MrSteam Installation

manual for additional control

installation information.

For Illustrative purposes only. Consult with

qualified designer, architect or contractor for

steamroom construction details.

INSTALLING A REMOTE TEMPERATURE PROBE

STEP 1

The Probe must be installed:

A. On a vertical surface

B. 4-5 feet above the Floor

C. In a location representative of the desired

steambathing temperatures. Do not locate the probe

above or near the steam head or direct steam emissions.

The probe has an integral 30 or 60 ft. cable. Ensure that

the probe and control are located accordingly.

STEP 2

Drill a 5/16 inch hole in the wall. Do not oversize or

undersize the hole. Clean area thoroughly.

STEP 3

Route the end of the temperature probe cable with the

temperature probe through a conduit inside the wall

cavity as shown in Fig 1.

WARNING The information in this guide is designed to provide a general overview of how MrSteam® products are installed. All images and diagrams are for illustrative purposes only

and may have been altered for presentation purposes. NEVER use this document for the Installation, Operation or Maintenance of any MrSteam® product. For installation, operation and

maintenance information and instructions, only use the applicable MrSteam® Installation, Operation & Maintenance Manual(s). The specific Installation, Operation & Maintenance manual

that is supplied with each MrSteam® product contains important information required for the safe and reliable installation and operation of the product. Failure to install any MrSteam®

product according to the applicable manual may result in property damage, an inoperable system/control, or hazardous condition. If you do not have the applicable Installation, Operation

& Maintenance manual please contact MrSteam® for a free copy, or download a copy from www.mrsteam.com. If you have any questions about the installation, operation or maintenance of

any MrSteam® product please contact a customer or technical service representative using the contact information on the back cover of this guide or consult a properly licensed contractor,

architect and/or design professional.

FIG 1

CABLE

SILICONE

SEALANT

FINISH WALL

1/4”Min

1/2”Max

MRSTEAM

GUIDE