Owners Manual

ManualsBrandsMr Steam ManualsPlumbingIButler Max Linear Steam Generator Control Kit / Package

CHROMASTEAM3

STEP 1

Locating the control box. Determine the desired location

of the ChromaSteam3 control box outside the steam

room in a dry location.

STEP 2

Installing the control box. Using screws and washers, af x

the control box to a stable vertical surface (e.g., stud)

using the mounting holes on either side of the control

box (Figure 1).

STEP 3

Install junction box. Remove one of the four knockouts

from the junction box. The resulting hole will allow routing

of the 30-foot control cable into the junction box. Locate

the two tabs on the junction box, and line them up against

a ceiling joist. The tabs locate the junction box proud of

(slightly raised from) the joist. Screw the two screws into

the ceiling joist to secure the junction box (Figure 2).

WARNING The information in this guide is designed to provide a general overview of how MrSteam® products are installed. All images and diagrams are for illustrative purposes only

and may have been altered for presentation purposes. NEVER use this document for the Installation, Operation or Maintenance of any MrSteam® product. For installation, operation and

maintenance information and instructions, only use the applicable MrSteam® Installation, Operation & Maintenance Manual(s). The specific Installation, Operation & Maintenance manual

that is supplied with each MrSteam® product contains important information required for the safe and reliable installation and operation of the product. Failure to install any MrSteam®

product according to the applicable manual may result in property damage, an inoperable system/control, or hazardous condition. If you do not have the applicable Installation, Operation

& Maintenance manual please contact MrSteam® for a free copy, or download a copy from www.mrsteam.com. If you have any questions about the installation, operation or maintenance of

any MrSteam® product please contact a customer or technical service representative using the contact information on the back cover of this guide or consult a properly licensed contractor,

architect and/or design professional.

For Illustrative purposes only. Consult with qualified designer,

architect or contractor for steamroom construction details.

CONTROL BOX

LED FIXTURE

FIGURE 1

FIGURE 2

NOTE: FOR MOOD LIGHTING ONLY.

35 MRSTEAM

GUIDE